Esprit Tech Elite T125 User manual

1
Esprit Tech (1) 321.729.4287
P.O. Box 360815 [e-mail]
Melbourne, FL https://www.espritTech.com
32936, USA
USER MANUAL
T125 is a tiny temperature sensor that supports multiple telemetry protocols. It can be used to measure
temperature of the electric engine, batteries and other aspects of your model.
FEATURES
-Small dimensions. The sensor is connected directly to the receiver telemetry port.
-Temperature min/max values are logged.
-Automatic telemetry detection: Duplex EX, Hott, MSB, S.Bus2.
-Configurable alarms on high temperature.
-Configuration through the transmitter.
-Firmware updates.
T125
Dimensions
22x8x4mm
Weight
0.8g
Temperature range
-10÷125°C
Temperature resolution
1°C
Operating current
4mA
Supply Voltage
3.5 –12V
Telemetry
Duplex EX, Multiplex MSB, Graupner Hott, Futaba S.Bus2
Status LED
NO
Installation
Connect the T125 directly to the receiver telemetry
port as shown in the picture.
JETIBOX Connection
Plug the T125 into the sensor slot of the JETIBOX.
Power it up with a battery (4.5 - 8.4V). Now you can
configure the sensor using the arrows on the
JETIBOX.
TELEMETRY AND SETTINGS
The device is compatible with JETIBOX for programming. The JETIBOX menu is divided into three sections:
•Actual values –displays the latest telemetry values together with minimums and maximums.
oReset Min/Max - press left+right buttons together to reset all minimums and maximums.

2
•Settings –basic settings of the sensor
oLanguage –you can choose the language of the JETIBOX screen.
oTemperature Alarm –you can set a high temperature alarm. *)
oAlarm Interval –sets the time period between alarm announcement.
•Service –In this menu you can view the device version and reset it to the default factory configuration.
*) The alarm setting is compatible with Duplex and Hott systems.
JETIBOX Menu Structure
Graupner Hott Menu Structure
The T125 is recognized by default as a General Air
Module. This can be changed to “EAM” or “Air-ESC”
mode through the menu.
Futaba and Multiplex connection
Futaba and Multiplex systems do not offer wireless device configuration. The telemetry transmission is
possible with the following fixed sensor slots:
Futaba S.Bus2
Multiplex MSB
Temperature
1
5
Note
Manual detection in the menu Linkage –Sensor.
Choose T125 on slot 1.
Automatically detected by the transmitter.
SAFETY INFORMATION
•Operate the T125 always in dry environment and within the device limits stated in this guide. Never
expose the device to excessive heat or cold.
•Do not remove the heat shrink tube from the device and do not try to implement any changes or
modifications. This can lead to a total destruction and to the denial of any warranty claims.
•Always check the polarity of the connection. Never inverse the polarity –this could lead to total
destruction.
WARRANTY
We grant a warranty of 24 months from the day of purchase under the assumption that they have been
operated in conformity with these instructions at recommended voltages and that they were not damaged
mechanically. Warranty and post warranty service is provided by the manufacturer.