Esse EL13 AMP User manual

Page 1
EL-I07-070814
CONTENTS.
Safety Instructions
Pg1
Control Panel
Pg9
Technical Data
Pg3
Ovens, Grill &
Warming Cupboard
Pg10
Unpacking your
New Cooker
Pg4
Induction Zone
Pg12
Installation
Pg4
Cast Iron Hotplate
Pg14
Connecting your
Cooker
Pg5
Before Using Your
Cooker
Pg6
Oven Steam Vents
Pg14
Your Cooker
Pg7
Extraction
Pg15
Spacing &
Dimensions
Pg8
SAFETY INSTRUCTIONS.
Please read these operating instructions carefully for full
information on the safe installation, use and care of your new Esse
appliance.
This appliance must be correctly installed in accordance with the
manufacturer’s instructions by a suitably qualified person.
We cannot accept responsibility for damage to persons or items
due to poor or incorrect installation of this appliance.
Make sure that the voltage and frequency of the mains supply
correspond to the details on the cooker data plate which is located
on the inside of the plate warming cupboard door.
Maintenance and servicing work must only be carried out after the
power supply has been disconnected by switching off at the socket
and removal of both plugs.
Due to our policy of continuous innovation, we reserve the right to
adjust or modify our product without prior notification.

Page 2
EL-I07-070814
Do not let children near the oven during use to avoid the danger of
burns or injury. Use of the appliance by the elderly or infirm should
be supervised.
The appliance and its accessible parts become hot
during use. Care should be taken to avoid
touching heating elements. Children less than 8
years of age shall be kept away unless
continuously supervised.
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
Unattended cooking on a hob with fat or oil can
be dangerous and may result in fire, NEVER try to
extinguish a fire with water, instead switch off the
appliance, cover the flame with a lid or use a fire
blanket.
Danger of fire: do not store items on the cooking
surfaces.
If the Induction zone glass is cracked or broken
the cooker MUST NOT BE CONNECTED and no
part of it may be used. Switch off and unplug the
appliance to avoid possibility of electric shock.
Metallic objects such as knives, forks, spoons and lids should not be
placed on the hob surface since they can get hot.
Any spillages on the heat conserving lids should be removed from
the lid before opening.

Page 3
EL-I07-070814
Do not use Steam cleaners to clean any part of this appliance.
Do not use external timers with this appliance.
This appliance can slip if placed on a raised platform.
If the any of the supply cords are damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Induction Zone: After use, switch off the hob element by its control
and do not rely on the pan detector.
During cooking, food naturally produces steam, which is vented
away to prevent excessive build-up within the ovens. As steam can
condense to water droplets on the cooler outer trim of the oven, it
may be necessary during cooking to wipe away any moisture with a
soft cloth. This will also help to prevent soiling and discolouration
of the oven exterior by cooking vapours.
TECHNICAL DATA
Fig.1 EL Cooker data plate.
The cooker data plate is located on the inner door panel of the
plate warming cupboard.

Page 4
EL-I07-070814
UNPACKAGING YOUR NEW COOKER.
Unpack your New Esse Cooker, removing all of the outer packing
and accessories from the top and bottom ovens, including
protective film on the door liners. At this time please examine the
cooker for any damage to the enamel finish and hob glass.
Any damage to the cooker or anything missing, please contact your
supplier for advice.
We ask that you dispose of any packaging in a safe responsible
manner and recycle where possible.
INSTALLATION.
Dear Installer
Before you start your installation, please complete the details
BELOW.
Installer’s Name
Installer’s Company
Installer’s Telephone number
Appliance Serial number
If your customer has a problem relating to your installation, they
will be able to contact you easily.
You must be aware of the following safety requirements &
regulations:

Page 5
EL-I07-070814
This appliance shall be installed in accordance with the regulations
in force and in a well-ventilated space.
Read the instructions before installing or using this appliance.
The cooker must be installed in accordance with: All relevant
British Standards / Codes of Practice and the relevant Building / IEE
regulations
Location of the Oven
This appliance is designed for domestic cooking only. Use for any
other purpose could invalidate any warranty or liability claim.
CONNECTING YOUR COOKER
For your own safety we recommend that a competent person
installs your cooker. This cooker is designed to be installed using
two standard 13 Amp plugs. A qualified electrician is not required.
Electrical connection
Ovens with a three-pole power supply cable are designed to
operate with alternated current at the supply frequency and
voltage indicated on the data plate (located on the inner door panel
of the lower right hand oven door).
Connecting the power supply cable to the mains.
The appliance is supplied fitted with two 1.5 metre cables and two
normalized 13 amp plugs which correspond to the load indicated on
the data plate. Before making the connections check that: the
circuit breakers or fuses of the home system can support appliance
load (see data plate); the power supply system has a sufficient
earth connection which complies with the provisions of current
regulations and the law; there is easy access to the socket. Do not
use reducers or adapters as these could cause heating or burning.

Page 6
EL-I07-070814
BEFORE USING YOUR COOKER
Remove plastic protective covers from inner door panels; lift up lids
and hinge covers.
Before you cook for the first time, it is recommended that both
ovens be switched on to the highest setting for about an hour to
burn off any initial odours
The grill should also be turned on for 15 minutes with the top oven
door left open, before it is used for the first time.

Page 7
EL-I07-070814
YOUR COOKER.
Fig.2 EL Cooker
1
PLATE WARMING CUPBOARD.
2
CONTROL PANEL.
3
INDUCTION ZONE.
4
HEAT CONSERVING LIDS.
5
CAST IRON HOTPLATE.
6
TOP OVEN & GRILL.
7
BOTTOM OVEN.

Page 8
EL-I07-070814
SPACING AND DIMENSIONS.
Fig. 3 EL Cooker Dimensions
It is recommended that a space of 10mm is left between the rear
wall and the rear of the cooker for maintenance purposes.
The cooker weighs 281kg and so the floor must be capable of
withstanding the load.
Make sure the cooker is level, use packing pieces if necessary.
The cooker does not require access via the side panels once it is
installed, however we do ask that a 3mm gap is provided between
the cooker top plate and adjoining work surfaces that may be fitted,
this is to allow for the safe removal of the top plate should this be
required at a later date.
It is not recommended that that no wall cupboards are fitted above
the cooker as steam may cause damage.
All dimensions are in mm

Page 9
EL-I07-070814
CONTROL PANEL
Fig.4 EL Cooker control panel.

Page 10
EL-I07-070814
OVENS, GRILL, WARMING CUPBOARD.
The ovens work by modulating the power (Patent Pending)
between the cast iron hotplate, the top oven, the lower oven and
the plate warming cupboard. If both ovens and the hotplate are on,
the cooker will modulate the power to reach the selected
temperatures, but if only one oven or the hotplate is turned on it
will heat up more quickly.
The cooker is designed to be used on slumber mode for the
majority of the day giving off a constant background heat and can
then heat up quickly to the required cooking temperatures when
required. However the cooker can simply be used as an On/Off
appliance if required.
The cooker consumes less than 1kW in slumber
mode at a room temperature of 18°C.
The top and bottom oven are controlled thermostatically and the
temperature markings on the controls are in °C. To switch one of
the ovens on, turn the corresponding knob clockwise to the desired
temperature. The indicator light will glow red to show that the oven
is heating up and will glow green when the oven has reached
selected temperature. Similarly when the control is moved to a
lower temperature the red light will flash until the oven has
reached the selected temperature, once the selected temperature
is reached the LED will glow green again. The control shows a red
flashing light after the oven has been switched off to indicate
residual heat.
The top oven.
This oven has a 2kW wrap around element (Patent Pending) and a
2kW grill element. The grill is a full width grill and takes priority
over the top oven control. The Top oven and grill can never be on
together, if the grill control is on at any position, then the top oven
will not work until it the grill is switched off.