Essential Medical Supply P1410 User manual

Model #P1410
Instructions for:
Height Adjustable Hand Bed Rail
with Security Strap
Hand Bed Rail Assembly
After laying all of the pieces out, use the
picture below as your guide.
User Weight Limit: 300 lbs.
Strap Instructions
1. Disengage the male half of the buckle by depressing the sides of the
buckle and pulling apart. Install male half on opposite end of strap by
inserting end of strap up through inside slot and back down through
outside slot (see photo).
2. At the opposite side of the bed, lift the mattress until the End Bar (D)
is visible.
3. Install strap by running male end around End Bar (D), across box
spring, and down side to frame.
4. Lift box spring, run around frame, and back to female buckle end.
5. Join buckle ends and adjust by pulling straps in either end of buckle.
WARNING: The Endurance®Hand Rail is not intended or designed to keep the user/patient conned to bed. If the
user is at risk to roll out of bed, a hospital style bed rail should be used. The Endurance®Hand Bed Rail is designed
to help the user get in and out of bed safely.
2011 ESSENTIAL MEDICAL SUPPLY, INC.®
1. Assemble the two Straight bars (A) by sliding
them over the long end of the L Shape Bars (B)
until the Locking Buttons snap into the hole of
the Straight Bar (A). Make sure that the Locking
Button of each respective L Shape Bar (B) is
facing out prior to assembly.
2. Slide the Hand Bar (C) over the short end of both
L Shape Bars until the Locking Buttons snap into
the adjusting hole.
3. Slide the End bar (D) into both ends of the
Straight bars (A) until the Locking Buttons snap
into position.
4. Slide the assembled unit between the mattress
and the box spring at a point on the bed where
it will be easiest to grasp the Hand Bar (C) when
getting out of bed.
5. Adjust the Hand Bar (C) to the desired height.
Hand Bar (C)
Height Adjustment
Buttons
L Shape Bar
- Left (B)
L Shape Bar
- Right (B)
The Locking
Button of the L
Shape Bar (B)
must face out
Straight
Bars (A)
End Bar (D)
The Locking
Button of the L
Shape Bar (B)
must face out
Buckle and Strap
Made for
Orlando, FL 32822