Etac 2Move User manual

2
3
Illustrations
Illustration 2
Illustration 1

2
3
3
Heading Page
1. General/Features ..................................................................................4
2. Practical handling.................................................................................5
3. Handling/Materials/Cleaning ................................................................6
4. Size/Combinations ...............................................................................7
Contents

4
5
General
Features
For use in transferring clients between two beds or from
a bed to an operation table, stretcher, X-ray or hygiene
table, etc.
Thank you for choosing an Etac product.
To avoid accidents and injury when moving and handling
the products, read the manual carefully.
The person described as "the client" in this user manual
is the person who is lying or sitting on the product. The
carer or carers are the people who manoeuvre the product.
The products comply with the standards applicable for
Class 1 products in the European Council Directive MDD
93/42/EEC on medical devices.
This symbol appears alongside the text in
the manual. It draws the reader's attention
to points at which there may be a risk to the
health and safety of the client or carer.
At Etac we strive to improve our products all the time
and therefore we reserve the right to make changes to
products without prior warning. All measurements given
on illustrations and similar material are for guidance only
and Etac cannot be held liable for errors and defects.
The information given in this manual, including recom-
mendations, combinations and sizing, does not apply to
special orders and modifications. If the customer makes
adjustments, repairs or combinations not predetermined
by Etac, the Etac CE certification and Etac warranty will
be voided. If in doubt, please contact Etac.
Warranty: Two-year warranty on material and manufac-
turing defects, provided that the product is used correctly.
For further information on the Etac transfer range, see
www.etac.com.
The product can be scrapped in accordance with national
regulations.
Washing
Handwash
Wipe off
Tumbledry
Iron
Do not dryclean
Do not bleach
Risk of sliding down
Never leave on the floor
Warning
Read the User Manual
Batch no./Lot no.
Max. weight
The product can be
scrapped in accordance
with national regulations
Manufacturer
Class 1 - European Council
Directive MDD 93/42/EEC
on medical devices

4
5
5
Use
Location
2Move incl. nylon cover and/or tube foil is positioned un-
der the client by rolling the the client slightly away from
the direction of movement, preferably using an absorbent
sheet. 2Move is positioned under the client after which
the client is rolled back.
2Move shall only be laid a few cm under the client. Posi-
tion the client's head and legs carefully onto the board. If
possible, it is helpful to cross the client's legs so that the
leg that is closest to the board is lowest with the other leg
crossed over it.
Use
By applying a little pressure to the shoulder and hip, the
carer can move the client over onto the other bed. If a
sheet is used, it is a good idea to position 2Move under-
neath the sheet. Positioning then takes place as described
above, but using the sheet to pull on (Illustrations 1 and 2).
2Move can easily be removed by sliding 2Move out from
under the client: The carer places one hand over the board
and the other under it. Then, the carer eases the nylon
material away with the upper hand while pulling towards
herself with the lower hand.
2Move can also be removed by first removing the board
from the cover and then removing the cover by pulling on
the down part.

6
7
Remember to use the client's resources.
Never leave the client on 2Move unless there is a
guard rail.
Never leave 2Move and/or the cover on the floor.
If in any doubt - please contact Etac.
Use
Always check the product before use and after washing.
Never use a defective product. If the product shows signs
of wear-and-tear, it must be scrapped.
Read these instructions carefully.
It is important that carers receive instruction in manual
handling.
Etac offers advice and training for carers.
For further information, contact Etac.
Always use the correct manual handling techniques.
Special features
2Move transfer board
Top side: 100% nylon.
Inner surface: wood.
Handles: polyester.
Cover: 100% nylon.
Disposable cover: Polyethylene.
The product should be checked regularly, preferably each
time it is used.
Check that seams and fabric are not damaged.
Never try to repair a product yourself. Never use
a defective product.
Materials
Cleaning
Washing instructions:
2Move transfer board:
Can be wiped off with disinfectant.
Cover:
Can be wiped off with disinfectant.
Do not use fabric softener.