ETC IRIDEON AR500 Installation instructions

IRID 110 AR500 Disassembly Instructions Revised: 7/27/2000 Page 1 of 2
IRID 110
IRID 110IRID 110
IRID 110
AR500 DISASSEMBLY INSTRUCTIONS
AR500 DISASSEMBLY INSTRUCTIONSAR500 DISASSEMBLY INSTRUCTIONS
AR500 DISASSEMBLY INSTRUCTIONS
Important Note
Important NoteImportant Note
Important Note
Units are static sensitive. Observe care when installing/servicing. Retain original packaging for
returns/service.
Stanchion
StanchionStanchion
Stanchion
Note: Make sure gaskets make a good seal whenever changing out parts.
Note: Make sure gaskets make a good seal whenever changing out parts.Note: Make sure gaskets make a good seal whenever changing out parts.
Note: Make sure gaskets make a good seal whenever changing out parts.
Ballast Plate
Ballast PlateBallast Plate
Ballast Plate
• Different Ballasts for different voltages
Composer Control Protocol Plate
Composer Control Protocol PlateComposer Control Protocol Plate
Composer Control Protocol Plate
• CPU
• Address Wheels √≈00∆is self-test
• LED»s √Green is data, yellow is power
• Comm protection PCB
• Power supply
• Fuse for Power to CPU
• Resistor
DMX512 Control Plate
DMX512 Control PlateDMX512 Control Plate
DMX512 Control Plate
• Address Board √Self-tests in the 900 range
• Power Supply √2 fuses
• CPU √2 fuses
• Power to board
• Data
• Igniter (remote stanchion)
• Remove cover from remote foot (loosen screws in diagonal pattern)
• Disconnect AC from T-block
• Remove screws from Igniter mounting plate and pull out igniter

IRID 110 AR500 Disassembly Instructions Revised: 7/27/2000 Page 2 of 2
Head
HeadHead
Head
Front and Back covers
Front and Back coversFront and Back covers
Front and Back covers
• Loosen 6 screws and remove head enclosure front cover
• Loosen 6 screws and remove head enclosure rear cover
• Loosen 3 clips to replace reflector
Lenses
LensesLenses
Lenses
• Loosen 6 captive screws
• Remove lens clamping ring and lens
• Remove gasket and place on new lens
Lamp and Socket
Lamp and SocketLamp and Socket
Lamp and Socket
• Remove 4 screws
• Pull socket out and replace lamp
Motors and Actuator Arms
Motors and Actuator ArmsMotors and Actuator Arms
Motors and Actuator Arms
• Using fingers or a short screwdriver, spread tabs of drive shaft and remove from brass swivel link
• Disconnect drive cable
• Locate and remove 3 screws attaching Linear Actuator Motor Assembly to head enclosure. Note
position of cable clamp.
• Slide the motor assembly out (be careful of shafts)
Color Filter Assembly
Color Filter AssemblyColor Filter Assembly
Color Filter Assembly
• Disconnect motors
• Remove 3 screws holding the Color Mechanism to the head enclosure
• Carefully slide the mechanism out of the head enclosure
Problems
ProblemsProblems
Problems
• Not many, solid unit
• Connector in hub can be mismade causing burnout