ETD Chameleon 6 Installation instructions manual

1410 Park Lane South Suite 4 - Jupiter, Fl – 33458
Phone [phone] • Fax [phone] • Email [e-mail]
Extreme Tactical Dynamics ©, 2018 page: 1
Chameleon 6 Mounting and Wiring Guide
The Chameleon 6 Traffic Advisor is designed
for easy installation. For best installation and
mount, we encourage you to have the unit
installed by a certified emergency vehicle
technician. Improper installation or use of this
light can void your manufacturer’s warranty,
cause damage to the unit or your vehicle, and
can result in injury. Please contact Extreme
Tactical Dynamics, if you have any issues
installing or mounting the Chameleon 6 traffic
advisor.
How to Mount the Chameleon 6 Directional
Controller
1. Carefully choose a location for the directional controller
2. Choose a location that is always dry and out of sunlight (we recommend under the instrument panel)
3. Keep the area free of dirt and dust (to avoid interfering with the light)
Chameleon 6 Wiring Tips
•Check that Chameleon 6 wires won’t interfere with airbag deployment or obstructions
•Use grommets, cable ties, and looms to keep wires protected and anchored properly
•Avoid wire splices whenever possible (can increase the risk of voltage drops)
•Cable should exit the emergency light on driver’s side of vehicle when installed
Wiring instructions
1. Connect red wires to positive terminal on pre-existing switch
2. Connect black wires to ground terminal

Extreme Tactical Dynamics ©, 2018 page: 2
Mounting Instructions for Chameleon 6 Traffic Advisor
•Install suction cup brackets on unit
•Wet suction cups
•Install suction cups
•Mount light in interior of vehicle.