Page 1 of 2 EDS1074-001
SET
C dE
Set Set
The first digit of the bottom box will be
flashing.
se the side arrow to move to next digit.
se up arrow to change digit in sequence.
Enter 0101.
Press return twice. (only)
Display should now read code in top line.
Lines two and three should be blank.
Set Display Li e At Start Up: This chooses what is displayed when the meter is first switched on. As default it is the single phase voltage.
p Arrow Set Set
Default Display Setting 1-7:
0001 = Volts 0003 = Amps
0002 = 3 Phase Volts 0004 = Kw
0005 = Frequency 0006 = Ept
0007 = Eqt
Press return twice.
To E able Cha ges To Meter Follow This Programmi g Seque ce:
Three Phase Board Meter I structio s: The meter has already been programmed and is ready to use, but should the meter need to be re-programmed in order to add other features then
the following process should be followed. Before a setting can be changed the meter has to be entered into programme mode.
Display Mea i g Display Mea i g
C dE Code pur Code Input
chAG Change Code sEr Set
clt.E Energy Clearance diSP Display
-Sn- Instrument Address In.Pr Signal Input
C nn Communication n.8.1 Data Bite 8, Stop Bite 1, No. Check
n33 3 Wire 3 Phase E.8.1 Data Bite 8, Stop Bite 1, Even Parity
n34 3 Wire 4 Phase .8.1 Data Bite 8, Stop Bite 1, Odd Parity
nEr Network bAUd Baud Rate
-pr- Voltage Ratio -Cr- Current Ratio
dArA Data Format FFrequency
EPt Positive Active Power E9t Positive Reactive Power
Technical Data: TPNMM
Clear E ergy Display (Reset):
Clears display.
Press set button three
times, energy will be
reset to zero.
C dE
Pur
Set
C dE
Pur
0000
C dE
Pur
0101
C dE SEr SEr
dISP
SEr
dISP
0000
p Arrow Set p Arrow
C dE SEr SEr
cLRE
SEr
cLRE
0000
