Eurotops 45212 User manual

MD719/ 1369 ELECTRIC CHRISTMAS TRAIN
INSTRUCTION MANUAL
- Please read the Operating instructions carefully before handling the little LED-light-
emitting train.
- Please keep carefully the instruction manual for future reference.
- When you submit this article to third parties, give him the present instruction
manual.
A. PRODUCT DESCRIPTION
Locomotive (x1)
Carriage A (x1)
Carriage B (x1)
Carriage C (x1)
Tracks (x8)
B. BATTERY INSTALLATION
Unscrew the
screw which is
to the back on
the locomotive
on the battery
compartment
cover.
Then, press black
tab to remove the
cover
Insert 2 batteries AA/
LR06 as indicated
inside the battery
box.
Reset the cover as
indicated on the
above drawing.
Screw the battery
cover back into
place. And be sure
that the screw has
been properly
tightened.
C. CIRCUIT SETUP
-Before proceeding to the setting up tracks, be sure that the floor surface is perfectly flat. The
circuit board must be placed on a clean stable flat surface, dust-free and non-fibrous (ex.
carpet fibers) so that the train can easily run straight through.
-If you mount the circuit on a table, be sure that the tracks are not closen to the edge of this
table. Because the cars could derail and fall in the empty space.
Before inserting batteries, insure that the train is off (reset the switch to the
OFF position).
English

1. Tracks layout setting up
In order to snap, proceed as indicated hereunder
DO NOT bend or damage the slots or the
rails tabs.
2. Two options of forms of circuit
D. LOCOMOTIVE AND CARS SET UP ON THE RAILS/ START UP OF THE TRAIN
Before the train starts, be sure that the wheels are correctly positioned on the rails. The smooth (a) and
toothed (b) edges on the front part of the wheels must be set on the rails (see photos of the steps 1
and 2). The contact of those parts to the train will facilitate the small train to start and turn around
several times till its manual shutdown of it (position on "OFF").
Note: When the train stops during the lap of the circuit, pleaser reposition the
wheels on the rails properly.
Note: To obtain this form, do not use
the below tracks:
1
2
1
2
3

E. WARNING ON BATTERIES
▪Please remove the batteries of the small train if you plan not to use it during a long period.
▪Never mix alkaline, standard (carbon-zinc) and rechargeable (nickel hydride).
▪Don’t mix new and used batteries.
▪Don’t attempt to recharge non rechargeable batteries.
▪Remove rechargeable batteries from the device (if possible) before charging them.
▪Rechargeable batteries must always be recharged under adult supervision.
▪Remove used batteries.
▪Never short the power supply terminals.
▪Always use the recommended or equivalent battery types.
▪Always pay attention to battery polarity.
F. CARE AND MAINTENANCE
•Do not use any aggressive cleaning agents (solvents, abrasive cleaning agents…).
•Clean the train, its wheels and the lines regularly using a soft slightly soft damp cloth.
•Do not expose to direct sunlight or other sources of heat, to dust and humidity.
•Do not expose to strong levels of vibration or severe knocking on hard surfaces.
•Stock the train in a dry location.
•Do not make any repair attempts to the train in case of any malfunctioning. Please contact
your local service dealer for any repairs.
•
WARNING: You should not dispose of this device with your household waste.
A selective collection system for this type of product is implemented by your local authorities. Please
contact your local authorities to find out how and where collection takes place. These restrictions
apply because electrical and electronic devices contain dangerous substances that have harmful
effects on the environment or on human health and must be recycled.
This symbol indicates that electrical and electronic devices are collected selectively. The symbol
shows a waste container crossed out with an X symbol.
Imported by EML/ Prodis 1 rue de Rome 93110 Rosny-sous-Bois-France/ Made in PRC
Marketed by EUROTOPS VERSAND GMBH D-40764 LANGENFELD
After carefully positioning the wheels
please connect the locomotive and the
cars together care being taken not to
shift the wheels out of the rails.
Note: The wheels must always be
properly positioned on the rails.
Turn the power switch on position
on (ON).
4
5