EverFocus ED230 User manual

EVERFOCUS
1/3" CCD IR Camera
Operation Instructions
Model No. ED230/330
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1. Do not have camera immersed in water.
2. Do not disassemble it or place it on an unstable base.
3. Do not touch the surface of CCD sensor by hand directly.
4. Never face the camera toward the sun.
5. Use proper power source otherwise the camera will not function correctly.
6. Use the camera at temperatures within -10℃~ 50℃and humidity between 20%~ 80%. The
input power source is DC 12V.

PREFACE
The ED230/330 Series Camera are compact, full functioned CCD IR Camera. Their stylish
appearance can be applied as per installer's ideal locations. These dome cameras can be
mounted either on the ceiling or on the wall easily. ED230/330 uses high sensitive 1/3" color
interline transfer CCD sensor, built in long life, high light & high reliability LED, sensors are
featured with Auto Electronic Shutter, Automatic Gain Control, and Auto White Balance function.
FEATURES
LED lifespan of 20,000 hours
Easy installation
Auto Electronic Shutter function
Automatic Gain Control function
Auto White Balance function
0 lux (IR ON)
Special optical low pass filter (inside) for high IR response
Automatically switches to black and white image when light levels fall below 1 lux
IR view angle: 75° range
IR distance: 10-15 M/ 33-49 feet
Available in 4.3mm with black base and shell or white base and shell
PACKAGE CONTENTS
zCamera Unit x 1
zManual x 1
OPTIONALACCESSORIES
zBA-ED- Mounting L-Bracket for ED Series Mini Dome Cameras

ED230/330
Type ED230 ED330
Pickup Device 1/3”SONY Super HAD CCD
Video Format NTSC or PAL
Scanning System NTSC: 525 TV lines, 60 fields/sec
PAL: 625 TV lines, 50 fields/sec.
Picture Elements 510 x 492 (NTSC) 768 x 494 (NTSC)
500 x 582 (PAL) 752 x 582 (PAL)
Horizontal Resolution 380 TV Lines 480 TV Lines
Video Output BNC 1.0Vp-p, 75 ohm
*Lens 4.3mm,6.0mm,8.0mm
*Lens models and availability vary in different regions
Sensitivity 0.3 Lux/F=1.2 (AGC ON) 0.4 Lux/F=1.2 (AGC ON)
0 Lux (IR LED on) 0 Lux (IR LED on)
Gamma Correction 0.45
S/N Ratio Over 48dB (AGC off)
Auto White Balance Yes
Electronic Shutter 1/50 (1/60) ~ 1/100000s
Black Light Comp. Yes
Auto Gain Control Yes
Sync. Mode Internal Sync.
Power Source 12VDC
Power Consumption 12VDC: 4W max.
Dimensions 108 mm (O.D.) x 80 mm (H) ; 4.3” (O.D) x 3.2” (H)
Weight 0.23 kg ; 0.5 lbs
Operating Temperature -10°C~50°C ; 14°F~122°F (20%~80% Humidity)
IR Distance 10-15 M/ 33-49 feet
IR Wavelength 850nm
Certifications FCC/CE

INSTALLATION
This section cover simple steps and detail installation. Please follow instruction for preventing
any unnecessary damage.
Simple Steps:
1. Open Camera Cover
2. Mount Camera on Ceiling or Wall
3. Connect power, video
Detail installation:
1. Open Camera Cover
Turn Clockwise to open it gently. Be careful not to damage the lens.
2. Mount the camera on ceiling or wall. Refer dimension b for drilling
dimension.

a) Ceiling mount
The dome camera is set in ceiling mount position as default.
b) Wall mount
The arrow indicator should be on the top when you do wall mounting. Unscrew the
fixing screws and rotate the camera module to the view angle you want
1. ED230/330 Dome camera's angle of view for lens is 83-degree.
Decide the location to install the Dome camera.
2. In application, the dome camera can be installed as the following two positions:
a) Ceiling mount
Full-Screen Width of View = 2 X
Distance between Camera and Target
Arrow Indicator
Fixing screws

b) Wall mount
Note!! Please make sure you connect power +,- correctly. Wrong Connection
damage the camera.
3. Connect Video and Power
a. Connect the BNC connector of the camera to a color monitor, or other video
device through a 75 ohm type coaxial cable with BNC female connector at
cable extension.
b. Connect the 12VDC regulated power source of the camera.

EverFocus Electronics Corp.
Head Office:
12F, No.79 Sec. 1 Shin-Tai Wu Road,
Hsi-Chih, Taipei, Taiwan
TEL: [phone]
FAX: [phone]
www.everfocus.com.tw
USA L.A. Office:
1801 Highland Ave. Unit A
Duarte, CA 91010, U.S.A.
TEL: [phone]
FAX: [phone]
www.everfocus.com
USA N.Y. Office:
415 Oser Avenue Unit S
Hauppauge, NY 11788
TEL: [phone]
FAX: [phone]
www.everfocus.com
Europe Office:
Albert-Einstein-Strasse 1
D-46446 Emmerich, Germany
TEL: [phone]
www.everfocus.de
China Office:
Room B-05D-1, KESHI PLAZA , Shangdi
Information Industry Base,
Haidian District, Beijing China
100085
TEL: [phone]/38/39
FAX: [phone]
www.everfocus.com.cn
Japan Office:
1809 WBG MARIBU East 18F,
2-6 Nakase.Mihama-ku.
Chiba city 261-7118, Japan
TEL: [phone]
FAX: [phone]
www.everfocus.com
Y
our EverFocus product is desi
g
ned and
manufactured with high quality materials and
components which can be recycled and
reused.
This symbol means that electrical and
electronic equipment, at their end-of-life,
should be disposed of separately from your
household waste.
Please, dispose of this equipment at your
local community waste collection/recycling
centre.
In the European Union there are separate
collection systems for used electrical and
electronic product.
Please, help us to conserve the environment
we live in!
Ihr EverFocus Produkt wurde entwickelt und
hergestellt mit qualitativ hochwertigen
Materialien und Komponenten, die recycelt
und wieder verwendet werden können.
Dieses Symbol bedeutet, dass elektrische und
elektronische Geräte am Ende ihrer
Nutzungsdauer vom Hausmüll getrennt
entsorgt werden sollen.
Bitte entsorgen Sie dieses Gerät bei Ihrer
örtlichen kommunalen Sammelstelle oder im
Recycling Centre.
Helfen Sie uns bitte, die Umwelt zu erhalten, in
der wir leben! EverFocus
®
P/N: MD23G00400 Ver. B