ExBrite 13MC2432V4LX User manual

LED Lighted Medicine Cabinet
W e bs it e: Htt p ://w ww. exb r it e u sa . c o m E ma i l : i nfo @ ex b r i te u sa . c o m H ot l i n e : + 1 3 0 2 3 36 8 1 80

LED Lighted Medicine Cabinet
Installation and Operating Manual
Series: 13MC2432V4LX
13MC2432V4RX
Size: W24''xH32''
For easy and safe installation, please refer to the following:
Read all instructions thoroughly before installing the enclosed product.
Read and take note of all safety, care and maintenance information.
PLEASE KEEP THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
DURING PRODUCT OPERATION AND MAINTENANCE.
W e bs it e: Htt p ://w ww. ex b r it e u sa . c o m E ma i l : i nfo @ ex b r i te u sa . c o m H o t l i n e : + 1 3 02 3 3 6 8 18 0

LED Lighted Medicine Cabinet
INSTALLATION INSTRUCTIONS
WARNING AND SAFETY INSTRUCTIONS
Before installing your LED Medicine Cabinet fixture,please make sure that you carefully
read through this instruction sheet, refer back to them during installation to ensure your
product is fitted safely and correctly. Keep these instructions for future use.
WARNING Risk of Fire and Electric Shock
●All fittings must be installed in accordance with current IEE wiring regulations. If in
doubt, consult a qualified electrician.
●Switch off the electrical supply at the main circuit board BEFORE installation and
maintenance.
●Suitable for indoor use only. This product should be positioned well away from
curtains and fabrics. Never cover the mirror.
●Regularly check the cord, the transformer and all other parts for damage, if any part is
damaged the product should not be used.
INSTALLATION SAFETY
●Inspect the product immediately upon receipt for any possible damage during
transportation or missing parts. Handle the product with care and protect against
knocks to all sides and edges of the glass.
●Ensure there are no hidden pipes or cables in the wall before drilling.
●Wear suitable eye protection when drilling. Take care if drilling on tiled surfaces in
case the drill slips.
CAUTION
The light source of this product is non-changeable light diodes (LED). Do not
disassemble the product, as the light diodes can cause damage to the eyes.
NOTE:The important safeguards and instructions that appear in this manual are not
meant to cover all possible conditions and situations that may occur. It must be
understood that common sense, caution and care are factors that can't be built into
any product. These factors must be supplied by the person(s) caring for and operating
the fixture. Do not install this fixture in hazardous locations.
W e bs it e: Htt p ://w ww. ex b r it e u sa . c o m E ma i l : i nfo @ ex b r i te u sa . c o m H o t l i n e : + 1 3 02 3 3 6 8 18 0

LED Lighted Medicine Cabinet
W e bs it e: Htt p ://w ww. ex b r it e u sa . c o m E ma i l : i nfo @ ex b r i te u sa . c o m H o t l i n e : + 1 3 02 3 3 6 8 18 0
Z-Bar x1
Z-Hook x1
Matching screws x2
Layer board supporting X4
for spare
Side panels x 2
Side panel lids x4 ,
Matching screws x10
REQUIRTOOLSED
PARTS SUPPLIED
Anchor x6
Wire caps x3
Round head screw
x6
22.2”x3.74”:
Glass Shelf x3
Hinge cover x3

LED Lighted Medicine Cabinet
W e bs it e : Htt p :// www.ex b r it e u sa . c o m E ma i l : i nfo @ ex b r it e us a . c o m H ot l i n e : + 1 3 0 2 3 3 6 8 1 80
Installation Instructions for Hanging Walls
Verify minimum clearances
76 [3”]
STEP
1
STEP
2

LED Lighted Medicine Cabinet
The side panels and cabinets are individually packaged ,
you need follow the STEP 5 to STEP 7 to install the side panels
for hanging walls version,for embedded installation no need
install the side boards.
Align the slots inside of the side
panels and cabinet.
Press down the side
panels until they are
clamped tightly with
the cabinet.
Installation Instructions for Hanging Walls
W e b sit e : Htt p ://w ww. ex b rit e u sa . co m E ma i l : i nfo @ex b r it e us a . co m H ot l i n e : + 1 3 0 2 3 36 8 1 8 0
STEP
3
Mark hole loca�ons on the wall.Drill
holes Insert anchors where needed
6
Secure the bar with round-head screws
STEP
4
STEP
5
STEP
6

LED Lighted Medicine Cabinet
Installation Instructions for Hanging Walls
W e b sit e : Htt p ://w ww. exb r it e u sa . co m E m a i l : i n fo @e x b r it e us a. co m H ot l i ne : + 1 3 02 3 3 6 8 18 0
STEP
7
STEP
8
White wire(Neutral)
Ground wire
Black wire (Hot)
3-connec�on cap

LED Lighted Medicine Cabinet
Installation Instructions for Hanging Walls
W e bs it e : Htt p ://w ww. ex b r it e u sa . c o m E ma i l : i nfo @ ex b r i te u sa . c o m H ot l i n e : + 1 3 02 3 3 6 8 18 0
Adjust corresponding screws on the hinge to align the doors, ensure
that gaps are even and the doors open and close smoothly
Install the glass shelf
Adjust gap between door and cabinet Install the Hinge cover

LED Lighted Medicine Cabinet
W e bs it e : Htt p ://w ww. ex b r it e u sa . c o m E ma i l : i nfo @ ex b r i te u sa . c o m H ot l i n e : + 1 3 02 3 3 6 8 18 0
Embedded Installation Instructions
Determine the size of the opening
105mm(4 1/8”)
STEP
1
White wire(Neutral)
Ground wire
Black wire (Hot)
3-connec�on cap
STEP
2
795mm(31 1/4”)
76mm(3”)
595mm(23 1/2”)

* All diagrams are for reference only. All model dimensions and proportions position will vary.
LED Lighted Medicine Cabinet
W e b sit e : Htt p ://w ww. exb r it e u sa . co m E m a i l : i n fo@ ex b r it e usa . co m H ot l i ne : + 1 3 0 2 3 36 8 18 0
Embedded Installation Instructions
STEP
3
STEP
4
STEP
5

LED Lighted Medicine Cabinet
Website: Http://www.exb r iteusa.com E mai l : i nfo@exb r iteusa.com H otline: + 1 302 336 8180
ON/OFF button
Color temperature button
UL socket with USB
3.6A
Night light
ON/OFF switch for night light only
DO NOT cover the sensor on the cabinet.


Oponal to stop night light funon by tapping
the ON/OFF switch at the boom of the cabinet.
Bright sensor
ON/OFF button
Dimming button
Defogger button

LED Lighted Medicine Cabinet
W e bs it e: Htt p ://w ww.ex b r ite u sa .c o m E m a i l : i nfo @ ex b r it e u s a .c o m H ot l i n e : + 1 3 02 3 36 8 1 80
A1 A2
Long press the A2 buon for 3 seconds to enter the me
adjustment mode. In this mode, short press A1 to decrease
& A2 to increase me. Each short press will reduce or ascend
the value by one. Or you can choose a long press for quick
adjustment. Aer the “hour” adjustment is completed, if
there is no more operaon for 5 seconds, it will enter the
“minute” adjustment mode, whose adjustment operaon is
the same as the “hour”. And aer the “minute” adjustment
is nished, it will automacally return to the normal mode if
there is no operaon for 5 seconds either.
Note: This product has me display & temperature display
funcon. 5 seconds for me display & 2 seconds will last for
temperature display. Each of them alternates. Remember to
adjust the mer only aer turn othe mirror.
Short press and touch buon to turn on/othe mirror.



is working.
Short press and touch buon to turn on/othe mirror.




Short press and touch buon to start defogging.



Note: Buon turns oaer a delay of 60 minutes.
the touch switches are with blue backlight.