
6
English
Basic functions
Shut off: Save energy
To avoid unnecessary electrical use, always turn the switch to the OFF position when
the device is not in use.
Radio reception
1. Set the function switch to AM or FM mode.
2. Turn the frequency selector to set desired station.
FM: Pull out and adjust the telescopic antenna for the best possible reception.
AM: For AM reception the built-in ferrite antenna is used. Turn the device to get
the best possible reception.
3. Adjust the volume with the volume control.
4. When you are done listening, set the function switch to the OFF position to shut
the power.
Playing a CD/MP3
The CD player can play Audio Discs, CD-R, CD-RW and discs that contain MP3 files.
1. Open the CD door by pressing and releasing on the edge marked
[OPEN/CLOSE] on the CD door.
2. Place a CD, CD-R or CD-RW or a CD with the label up and shut the door.
3. Set the function selector to CD. On the display - - - is shown shortly before
the total amount of tracks are displayed.
4. Press [►II] to start playback.
5. Press [►II] to stop playback temporarily. Press again to continue playback.
6. Press [STOP] to terminate the playback.
Note! The playing of CD or MP3 stops even
- If you open the CD door.
- When you move the switch to AM, FM or OFF.
- When entire CD has been played.
Playing MP3 files from a USB memory
The device can play MP3 files from a USB memory. The device supports
USB 1.1 and 2.0.
1. Connect a USB memory to the USB connection (18) on the front of the device.
2. Set the function switch to position CD/USB.
3. Press and hold [CD
USB] for about 2 seconds to activate playback from USB
memory. On the display - - - is shown shortly before the total amount of tracks are
displayed.
4. Press [►II] to start playback.
5. Press [►II] to stop playback temporarily. Press again to continue playback.
6. Press [STOP] to terminate playback.