Extech Instruments 42530 User manual

User’s Manual
High Temperature InfraRed Thermometer
with Laser Pointer
MODEL 42530
Introduction
Congratulations on your purchase of the Model 42530 IR Thermometer. This thermometer
makes non-contact (infrared) temperature measurements at the touch of a button. The
built-in laser pointer increases target accuracy while the backlit LCD and handy push-
buttons combine for convenient, ergonomic operation. Proper use and care of this meter
will provide years of reliable service.

Model 42530-EU V2.4 5/09
2
Safety
Use extreme caution when the laser pointer beam is on
Do not point the beam toward anyone's eye or allow
the beam to strike the eye from a reflective surface
Do not use the laser near explosive gases or in other
potentially explosive areas
Specifications
Infrared Thermometer Specifications
Range / Resolution -50 to 538oC (-58 to 1000oF) 0.1°C/F<200 / 1oC/F> 200
Accuracy ± 2% of reading or ± 2oC (4oF) whichever is greater.
Note: Accuracy is specified for the following ambient
temperature range: 18 to 28°C (64 to 82°F)
Emissivity 0.95 fixed value
Field of View D/S = Approx. 8:1 ratio (D = distance, S = spot)
Laser power Less than 1mW
Spectral response 6 to 14 m (wavelength)
General Specifications
Display 3½digit backlit LCD display with function indicators
Display rate 1 second approx.
Operating Temperature 0°C to 50°C (32°F to 122°F)
Operating Humidity Max. 80% RH
Power Supply 9V battery
Automatic Power Off Meter shuts off automatically after 7 seconds
Weight 180g / 6.35 oz.
Size 211 x 89 x 38mm (8.3 x 3.5 x 1.5”)

Model 42530-EU V2.4 5/09
3
Meter Description
1. LCD Display
2. Function Buttons
3. Handle Grip
4. Laser Pointer
5. IR Sensor
6. Measurement Trigger
7. Battery Compartment
Operating Instructions
1. Hold the meter by its Handle Grip and point it toward the surface to be measured.
2. Pull and hold the red Trigger

Field of View
The meter’s field of view is 8:1, meaning that if the meter is 20.3cm from the target, the
diameter of the object under test must be at least 2.54cm. Other distances are shown
below in the field of view diagram. Refer to the chart printed on the meter for more
information.
Measurement Notes
1. The object under test should be larger than the spot (target) size calculated by the field
of view diagram (see diagram on previouspage or on side of the meter).
2. If the surface of the object under test is covered with frost, oil, grime, etc., clean before
taking measurements.
3. If an object's surface is highly reflective apply masking tape or flat black paint before
measuring.
4. The meter may not make accurate measurements through transparent surfaces such
as glass.
5. Steam, dust, smoke, etc. can obscure accurate measurements.
6. The meter compensates for deviations in ambient temperature. It can,however, take
up to 30 minutes for the meter to adjust to extremely wide ambient temperature
changes.
7. To find a hot spot, aim the meter outside the area of interest then scan across (in an up
anddown motion)until the hot spot is located.
Battery Replacement
When the low battery symbolappears on the LCD, replace the meter’s 9V battery.
The battery compartment is located on the bottom of the meter's handle. Open the
compartment by sliding the battery compartment cover off in the direction of the arrow.
Replace battery and re-install the battery compartment cover.
You, as the end user, are legally bound (Battery ordinance) to return all used
batteries and accumulators; disposal in the household garbage is prohibited!
You can hand over your used batteries / accumulators at collection points in your
community or wherever batteries / accumulators are sold!
Disposal: Follow the valid legal stipulations in respect of the disposal of the
device at the end of its lifecycle
Copyright©2009 Extech Instruments Corporation.
All rights reserved including the right of reproduction in whole or in part in any form.
2.54cm
5.08cm
1.6cm
Distance to Object
Diameter of Spot
Laser Beam
10.1cm
10.1cm
20.3cm
40.6cm
81.2cm
1.27cm
Sensor Beam
more infor for Extech 42530
Phone: [phone]
Email: [e-mail]
Web. www.airconcern.co.uk
Air Concern Ltd, Building 173 Curie Avenue Harvell Didcot, Oxfordshire