FACE ID BIOMETRICS F710X User manual

4
Page 4
Installation Environment
Note:
.
5
Page 5
Mount On Wall
A B
User can drill the holes according to the
mounting diagram. Use the 4 Wall Mount,
User also could mount the terminal by
your “shortest”users and have
them stand in front of the device.
Hold the terminal on the wall and make
sure the employee can comfortably center
their faces in the LCD display window.
Mark the height of the terminalon the wall.
Taller employees can easily adjust their stance to center their face in the LCD display window.
For detailed wall mounting instructions please refer to the User’s Guide.
Align the terminal with the pairs on
-plate and secure the
a bracket SHC
. Be careful not to pinch the
. When finished,plug the
wall outlet.
choosing
the Mounting
two together with the
screws
AC cord
Power Adapter into an AC
screws to mount the bracket to the wall.

7
Page 7
Enroll User
From the main home screen, press the <MENU> key. The
Administrator must present their face.
Press the <2> key on the keypad to access the User Management
Menu.
Enter the ID Number of the user and
press the <OK> key.
Enter the name of the user and press the <OK> key.
Press the <related> key to select the verify method.
Enroll the related information according to verify method
selected.
Confirm the user privilege type, press the <OK> key.
Complete these steps until all employees are enrolled.
More enroll user information, please check the user manual.
1
2
3
4
5
6
7
6
Page 6
Enroll Administrator
1 When the terminal is powered up and at the home screen, press
<MENU> key.
After pressing the MENU key, the Functions Menu will open.
Press the <1> key on the keypad to start the Admin Enrollment
process.
Confirm admin. type with "Super Admin.".
Press the <1> key on the keypad to select Admin 1 and begin
the Admin. Enrollment.
Enter additional Administrators as necessary at this time by repeating
the steps above.
When complete, press the <ESC> key multiple times to return
to the main default screen.
More enroll admin. information, please check the user manual.
Please review Face Enrollment Tips section on page 7 before face enrollment.
The first administrator must be super admin.
Enroll the admin. in these steps: Input ID→Name→Select Verify
Method and then finished enroll process.
the
2
3
4
5
6
7

8
Page 8
Face Enrollment Tips
The line of squares at the bottom of the screen
indicate how much data is needed to complete
enrollment.
The progress bar
shows status of
enrollment.
1. Progress Bar
Half with Glasses
If you wear glasses all of the time, or on occasion, you
must initially enroll with your glasses on (sunglasses or
dark tinted glasses are not allowed). Once the progress
bar indicates enrollment is about 50% complete, REMOVE
YOUR GLASSES and complete the enrollment without
your glasses on.
6. Wear Glasses?
Move your face from close to far while making very small circles
until green box disappears.
5. Adjust Distance
Focus on dashed box
The white dashed box is preparing to locate
en box appeares inside the dashed box.
2. Camera Feedback
face. Enrollment will progress when the gre
3. Position
Position yourself and bend at the waist to
30-80 cm
bring your face 30~80cm, from the screen
on the terminal. Position your face close to
screen is suggested at the begining of enr
ollment. Make sure the green box appears
inside the white dashes box.
Good!
4.
Slowly make very small circles with your face while
keeping eyes centered on the screen during enrollment.
The angle shall not more than 15 degree while
Very Small Circles
turning up, right, down, left for circling.
Move fartherMove closer Half without Glasses
Note:
Block Eyebrows Close EyesSunglasses Respirator GrimacsNormal Position