FALCON RIDGE BC-3400-WD05 Operation manual

2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Bobcat 3400
Aero-VentPolycarbonate Windshield
BC-3400-WD05 / 50-40046
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are
happy with the product before removing protective film. Once the film is removed you cannot return the product
for a full refund.
Be sure to read these instructions thoroughly before opening and installing the Polycarbonate Windshield.
1. Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Check
over the parts included in the cartons with the parts list shown below:
1 ¾” Loom Clamps 8 each
1” Stainless Steels Bolts 14 each
Stainless Steel Washers 20 each
Slide fasteners 8 each
Lock Nuts 4 each
Plastic Thumb Nuts 10 each
Sliding Vent Panels 2 each
52” Rubber Gasket 1 each
55” Rubber Gasket 1 each
Bent Polycarbonate Braces 1 each
Polycarbonate Windshield 2 Pieces
If any parts are damaged or missing please contact customer service at [phone].
2. Next take the rubber gasket and starting at one end firmly place along entire bottom and top edges of the
lower Windshield Section. You will need to peel back the protective film from the edge to install the
gasket. If you leave the bulk of the protective film on while installing you can keep from scratching the
windshield. Please see photo below:

3. Next Install the Aero-Vent sliders as shown in the diagram on the following page.

4. Next take the bent Polycarbonate brace and install it on the windshield. Please see diagram on the next
page.
5. Now you are ready to place the windshield on the Bobcat and attach to the roll cage. NOTE: THE
BEND AT THE TOP OF THE WINDSHIELD SHOULD GO BELOW THE TOP TUBE. The diagram

on the next page shows the proper placement for the hardware. Install the clamps as shown for the top
two slots in the windshield only. Use the 1” bolts for this application.
6. Now Place the two halves onto the frame as shown on the next page. (diagram not Bobcat)
7. Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of
some sort to decrease the chance of scratches. We recommend using micro fiber cloths that are readily
available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag
or micro-fiber cloth to clean it.

Thank you for your purchase!
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the
terms under which your product is covered under our manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to
defect of the product. Please refer to the return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct
the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement
we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of
purchase.