Fanimation Palmetto FP600 Series User manual

Copyright 2007 Fanimation, Inc. 2007/12
10983 Bennett Parkway
Zionsville, IN 46077
Toll Free [phone]
FAX [phone]
Outside U.S. call [phone]
Visit Our Website www.fanimation.com
The Palmetto®Ceiling Fan Assembly
INSTALLATION REQUIREMENTS:
It is recommended that each drive shaft support requires backing consisting of 3/4˝plywood (20˝x 20˝) attached to the
ceiling joists, snug above the sheet rock, and able to support 100 lbs. Not recommended for sound-sensitive areas.
ELECTRICAL REQUIREMENTS:
The drive shaft support that contains the motor will require a 120 VAC, 60 Hz, 15 amps electrical feed via a flush mount
junction box positioned on center and wired back to an on/off switch (motor unit is single speed). Any support that
contains a light fixture will also require a junction box on center with a circuit wired back to a dimmer circuit or on/off
switch. The lights and motor should be on separate switch legs.
FAN SPEED:
Single-speed, 15 rpm; NOT designed for significant air movement.
BLADE OPTIONS:
Various Palm and Bamboo blades are sold seperately. See Catalog or visit our website, www.fanimation.com for more
blade selections.
LIGHTING OPTIONS:
Optional lighting fitters and light kits are available, including a single bowl fixture with a maximum of 180 watts and
a variety of four-light fixtures with a maximum of 240 watts. Can be only mounted on the cap housing. Installation
instructions provided with each light fitter and light kit. See Catalog or visit our website, www.fanimation.com for more
lighting options.
DAMP LOCATION:
Fan not rated for Damp Location usage.
SPECIFICATION SHEET
Product Specifications subject to change
The Palmetto®
FP600 Series

The Palmetto® Fan Assembly
Motor Assembly Unit*
Chain-Driven, 115 volt, 60–50 Hz,
0.62–0.76 amps, 1/20 hp
220 VAC, 50 Hz export version available
Finishes: available in 3 finishes
**Available Finish (codes)
AB Antique Brass
BL Black
Ordering Information (Items Sold Seperately)
Item Catalog No. Description
Fan Assembly
FP601**
FP602**
FP603**
FP604**
FP605**
One Section
Two Sections
Three Sections
Four Sections
Five Sections
Blade Sets
(Includes Blade
Holder, Stem and
Hub)
Up to 3 blade sets can be
used per section.
See Catalog or visit
www.fanimation.com for
more blade information
Dimensional Information
A Overall Length*10´– 50´
B Support Spacing†
119˝(center of base
to center of base)
10´ 5½˝(outside of base
to outside of base)
C Ceiling to Shaft 27˝
D Base Width 6˝
E Base Length 18˝
F Blade Sweep 48˝
G Overall Drop 51˝
H Blade Radius 24˝
I Blade Length 18˝
J Base Stem Length 4˝
C
B
A
D
E
F
G
**Insert Finish Codes
Dimensions shown in feet & inches
*Available 9´ to 45´ (depending on number of sections)
†Supports can be spaced from between 48˝to 119˝.
Outside of base to outside of base, if entire 108˝shaft is used.
Shaft is cut to length required at installation.
NOTES: Not designed for significant air movement.
Not recommended for sound-sensitive areas
(chain-driven motor).
I
H
J
Blades To Floor
7´ minimum
*NOTE: Not recommended for sound-sensitive areas!