faucet strommen 36015 User manual

Suits Models:
36015 36016 36017 36018 36019 36020 36021 36022 36023 36024 36025 36026
36027 36028 36029 36030 36031 36032 36033 36034 36035 36036 36037 36038
36039
Important requirements:
This product is designed to be installed onto cabinet door and drawer fronts. 40mm
screws have been supplied for regular front thicknesses, refer drawing below for details.
Cleaning
Clean only with a soft microfiber or similar cloth and warm clean water. Ensure that
the cloth is clean and free of any grit or chemical. Dry fitting o with a soft clean cloth.
Ensure that your fitting is not subject to any chemicals, building grit or any type of
abrasive of polish. For care of special finishes please visit our website.
Products Warranty – Australia
For warranty details see our website:
https://www.faucetstrommen.com.au/warranty/
IG 042
Cabinet Bar Pull
Faucet Australia Pty Ltd ABN 83683523321 31 Tate Drive, Kerang VIC 3579
www.faucetstrommen.com.au P: [phone] sale[email protected].au
Release Date: 13.12.23
Installation Guide
64 / 96 / 128 / 160 / 320
144 / 176 / 208 / 240 / 400
28
10
Front thickness 15 ~ 25
64 / 96 / 128 / 160 / 320
144 / 176 / 208 / 240 / 400
28
10
Front thickness 15 ~ 25
64 / 96 / 128 / 160 / 320
144 / 176 / 208 / 240 / 400
28
10
Front thickness 15 ~ 25
96 / 128 / 160 / 192 / 352
126 / 158 / 190 / 222 / 382
30
Front thickness 15 ~ 25
11
96 / 128 / 160 / 192 / 352
126 / 158 / 190 / 222 / 382
30
Front thickness 15 ~ 25
11

Installation
1. Measure and Mark: Determine the ideal placement for the bar pull on your door or drawer. Use
a measuring tape to find the center points of the fixing points, then mark a cross with a pencil.
Hold the cabinet pull against the door or drawer front to confirm positions.
2. Pre-Drill Holes: Use a 4.5 mm drill bit to pre-drill holes at the marked locations.
3. Attach Bar Pull: Place the bar pull against the door or drawer front again and make sure the
holes are aligned. Insert the screws through the holes and thread into back of the cabinet pull.
Re-check alignment then tighten firmly using a 2 mm Allen Key.
64 / 96 / 128 / 160 / 192 / 320 /352 (check specific model)