FIBARO FGBHS-213 User manual

Single Switch (FGBHS-213)
FIBARO Single Switch is designed to be installed in standard wall
switch boxes or anywhere else where it is necessary to control electric devices.
FIBARO Single Switch allows to control connected devices either via HomeKit technology (using
Bluetooth® low energy) or via a switch connected directly to it and is equipped with active power
and energy consumption metering functionality.
Wiring diagrams
Descriptions for wiring diagrams:

1 - Live wire
2 - Neutral wire
3 - Load wire
4 - Switch button wire
5 - Switch power wire
Wire colours are only indicative, consult electrician to make sure which wire is which.

First launch
1. Switch off the mains voltage.
2. Open the wall switch box.

3. Disconnect the wiring from the switch.
4. Switch on the mains voltage.
DANGER OF ELECTROCUTION!

5. Identify the Live wire using voltage tester.
6. Switch off the mains voltage.

7. Connect Live wire to L terminal and power terminal of switch.
8. Connect Neutral wire to N terminal.

9. Connect Load wire to Q terminal.
10. Connect S1 terminal to button terminal of switch.

11. Put device and wires in and close the wall switch box.
12. Switch on the mains voltage.

13. Open the FIBARO app and tap + icon.
Application will guide you through the pairing process.
Reset
DANGER OF ELECTRUCUTION!
1. Open the wall switch box.
2. Press and hold the button.
3. When the LED glows yellow, release the button.
4. Click the button to confirm.
5. Accessory will glow red to confirm reset.