Fiber Instruments Sales CA6 User manual

0
Using Keypad
Start and cancel
heating cycle Power ON/OFF
Set
Heate
r
Reset
Splice program Heater program SD Power Time
Heater panel
Control panel Home Screen icons
Display the Settings panel
Power source type
Change image view
Display/Non-display icons
Start the splicing process
Start the heating process
View splice data after splicing
Adjust the zoom of a fiber image
Adjust display brightness
Capture a fiber image
To display the Settings panel, tap the
Settings panel icon ( ) on Home screen.
■Settings panel
■Home screen
Display the menu screen.
Set up Splice Program.
Set up Heater Program.
Log in to Administrator
mode by entering passcode.
Adjust the volume.
Perform an arc test.
Settings panel icons
CA6
Quick Reference Guide

2. Fusion splicing is completed. 3. Open the wind hood. A proof
test is automatically carried
out.
4. Remove the fiber from the
splicer. Center the protection
sleeve over the splice and
load the fiber in the heat
shrink oven.
Operating Procedures
1 Splice program setting
1. Tap the Splice program label
on the Settings panel. 2. Select fiber category. 3. Tap the splice program you would like to use.
* Setup and change the Heater program in the same procedures as described above.
Heater progress bar
Heating in progress
Cooling
Standby
5. Tap Heater icon or press
Heater key to start the
heating process.
1. Tap Set icon or press
Set key to start the
splicing process.
2Perform an arc test
1. Tap “Arc Test”. 2. After “Arc Test Ready
”
appears, tap Set icon. An
arc test is started.
3. When the splicer shows
“Good arc state”, prepare fiber
again to proceed to the
splicing process. *Fibers are
not spliced in the arc test.
* Repeat fiber preparation and arc tests
until “Good arc state.” is displayed.
Operating Procedures
3Start splicing process / Start heating cycle
OME1724079-9/Ver.1.00
*AS24F879*