FICO SB-815ER Quick guide

Baby Walker
Use Instructions
SB-815ER
Dear users,
Thank you for your purchasing. Please read the instructions carefully before use and keep
them for future reference. It is concerning correct and safe assembly and use of the baby walker.
The child may be hurt if you do not follow these instructions
WARNING — Never leave the child unattended.
WARNING — The child will be able to reach further and move rapidly when in the baby walker.
Use Instructions:
1. Assembled by adult
2. Prevent access to stairs, steps and uneven surfaces;
3. Guard all fires, heating and cooking appliances;
4. Remove hot liquids, electrical flexes and other potential hazards from reach;
5. Prevent collisions with glass in doors, windows and furniture;
6. Do not use the baby walker if any components are broken or missing;
7. This baby walker should be used only for less than 20 minutes.
8. This baby walker is intended to be used by children who can sit unaided, approximately from 6
to 12 months(excluding 12 months). It is not intended for children weighing more than 12 kg;
9. Do not use replacement parts other than those approved by the manufacturer;
10. Insert two 1.5V5＃batteries with the correct polarity.
11. Use non-rechargeable batteryes. Different types or new and used batteries can not be used in
mixture. Exhausted batteries should be removed.
12. The supply terminal is not to be short-circuited.
13. Please keep all the relevant information for future reference.
Maintenance Tips:
1. Make sure every fastening pieces are tightened before use.
2. Please check the child car over regularly, and keep it in safe places when not used.
3. Grease revolving parts such as the friction points of every axles and rotatable parts to
guarantee flexibility with solid oil to prolong the life span, and check and fasten the screwed
joints once a week.
4. Do not use or store in moist , frigid or high-temperature environments.
Install Instruction
Step 1: Insert wheels into the wheel axel holes
under the base plate respectively, and press the
wheel axles into the bottom in order to avoid
dropping down. (Figure 1)
Step 2: Put the PVC strip sewed on back of seat
cloth into the reserved groove on the top tray of
the walker. The hook seat holes of PVC strip
aim at the hook teeth in the groove, and press
them into it with the thumb or forefinger.
(Figure 2).
Step 3: Install Toy Music Tray
Open the cover of battery box at the back
of the toy tray, install two 1.5 AA batteries, and
then the toy tray can be operated.Put the toy
tray in the reserved place of top plan, aim at the
psition to insert into it, and button the toy cover
in order to avoid dropping down.
Notes:Different typs or new and used batteries
can not be used in mixture.When the batteries
are not use,please take them out. The supply
terminal are not to be short-circuited.(Figure 3)
Step 4: Adjust the Height of Top Tray(Figure
4&5)
1.The lock and the trough are at the same
direction for up.
2.Press the lock up for down.
3.Press the lock down and turn it around for
locking.

F u n t i o n d i a g r a m
The music box can be taken out as an
independent toy,it has kinds of music and
small toys to be olayed with.And it canbe
placed into the walker for child to learn
speaking.
Remove the back cloth,poke limit switch
both sides at the same time till the end,leave
ip tray down to bottom,then let it go
Non-slip slice:It can prevent the baby
walker from bouncing out when in a
flight of stairs.
Haul the two buttons up which on the
same side of the bottom tray at the same
time,and floor,then leave go of.
The operation of the other side is
thesame.