Fiilex QUAD COLOR User manual

1. Fan Intake Vent
2. ON/OFF Switch
3. Vent Holes
4. Tilt Lock Lever
5. Yoke
6. USB Type-A Port (5V/1A Power)
7. DMX Iutput (XLR-Male 5-pin)
8. Junior Pin Receiver
9. Handle
10. OLED
11. Intensity Control Knob
12. CCT/HUE Knob
13. GN/SAT Knob
14. Navigation Pad
15. USB Type-C Port
(For updating firmware)
16. LAN Port
17. DMX Output (XLR-Female 5-pin)
18. AC Input Port
Parts Diagram
Safety Instructions
User Guide
• DO NOT disassemble QUAD Color. This will void the warranty.
• DO NOT install QUAD Color in damp or wet locations.
• DO NOT obstruct the fixture’s air vents.
• Use safety cable (not included) when rigging QUAD Color overhead.
• Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
• The luminaire is intended for professional use only.
• Do not look into the light source with any instrument that could concentrate the light output: this includes magnifiers, binoculars,
telescopes, etc.
• This fixture corresponds to Risk Group 1 according to EN 62471 under normal operation condition, which considers all photobiological
risks. It corresponds to Risk Group 1 according to EN 62778 under those conditions, which considers risk from blue light only.
• The light output can potentially cause eye injury if stared at for a prolonged period of time
1
4
5
6
8
7
3
9
18
16
15
14
13
11
10
12
17
2
03282023A

1689 Regatta Blvd. Richmond, CA 94804 | [phone] | [e-mail] www.fiilex.com
Off The fan is completely off. (Operation time is limited.)
The fan speed varies based on light intensity.
The fan operates at reduced speed.
The fan operates at full speed.
Variable
Silent
Full Speed
Sharp Best for flash and strobe effects.
Best for gradual fades.
Smooth
Settings
Fixture Operation
Mode Selection
Fixture Control
Use Navigation Pad to enter MODES menu, then
navigate to select the desired mode.
1 Manual / Local :
Use Intensity Control Knob or the Navigation Pad
to control the parameters.
For CCT modes and HSI modes, use either CCT/HUE
Knob and GN/SAT Knob or the Navigation Pad .
2 DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or
DMX OK.
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access additional settings.
View current fixture firmware versions and fixture
temperature.
Modify ArtNet and sACN settings of the fixture.
Fan speed options
Dimming options
Info
Ethernet