FireplaceXtrordinair 864 TRV (Top/Rear Vent) User manual

864TRV Rectangular Face
Black 95800623
Nickel 95800624
Page 1 of 4 17601486 - 8/30/10 © Travis Industries, Inc.
Compatibility:
• 864TRV Fireplace
• 864ST Fireplace
• 864HO Fireplace
Packing List:
• Face • (12) 8-32 Nuts
• Face Mounting Brackets (upper and lower sets) • (2) 10-24 1-1/2" Screws
• (2) Face Brackets (w screws)
Installation Details
SIDE OF FIREPLACE
1”
5/16” TO 1”
NOTE:
This face has an adjustable bracket that allows for
different facing depths to be tucked under the face.
40-7/8”
35-5/8”
Special Instructions for 864HO Fireplaces
This face requires the outer grill deflectors to be removed. See the instructions below.
Remove the outer deflector on both sides
(use needle-nose pliers if necessary).
These tabs bend down
to allow for removal.
Re-attach the deflectors to the top louver
for future use if using a different face or
grill. Bend the tabs as shown, making
sure the deflectors are secure and flat.

864TRV Rectangular Face
Black 95800623
Nickel 95800624
Page 2 of 4 17601486 - 8/30/10 © Travis Industries, Inc.
Installation
1 Attach the brackets to the fireplace following the directions below.
Repeat these steps for the opposite side.
Upper
Bracket
Lower
Bracket
Upper
Left
Lower
Left
Upper
Right
Lower
Right
Bracket
Identification
Remove and discard the nuts and bushings
above and below the firebox.
Place the upper and lower brackets in place
and secure using the nuts included with this
kit.
Discard the stock
bushings and nuts.
Discard the stock
bushings and nuts.

864TRV Rectangular Face
Black 95800623
Nickel 95800624
Page 3 of 4 17601486 - 8/30/10 © Travis Industries, Inc.
2 The facing and hearth (if applicable) must be installed prior to attaching the face. See the installation manual
for complete details.
Raised
Fireplaces
























































Note how the tile is 1”
(maximum) above the
base of the fireplace.




















































Maximum 1`” Hearth
Floor-Level
Fireplaces





864TRV Rectangular Face
Black 95800623
Nickel 95800624
Page 4 of 4 17601486 - 8/30/10 © Travis Industries, Inc.
3 Install the face following the directions below.


























































Attach the upper brackets
to the face with the
included nuts.
Slide the face into place. The
tabs on the upper brackets insert
into the slots on the fireplace
brackets, holding the face in place
while the screws are tightened.
a
b
The face is secured to the fireplace
with four screws. Two of the screws
are fastened to the upper brackets
with press nuts. The lower screws
are included with the face.
Plated Surfaces
Use denatured alcohol and a soft cloth to clean plated surfaces. Marks
left on the surface may damage the face.
Denatured
Alcohol
Soft Cloth