FireplaceXtrordinair 564 Rectangular Face User manual

564 Rectangular Face
Black 95400411 Nickel 95400413
Page 1 of 4 17601478 4/1/16 © Travis Industries, Inc.
Compatibility:
• 564 SS & DF Fireplace
• 564 HO Fireplace
• 564 564 EF-I Fireplace
Packing List:
• Face • (4) 8-32 Nuts
• (2) 564 Top Brackets (w screws)
• (2) 564 Upper Mounting Brackets
• (2) 564 Lower Mounting Brackets
• (2) 10-24 1-1/2" Screws
The center deflectors must be in place when using this face to prevent
the facing above the fireplace from becoming too hot. If this face is
replacing a Lopi Grill (96200801), make sure to replace the center
deflectors.
Installation Details – 564 SS, DF, HO
SIDE OF FIREPLACE
1”
0” TO 1/2”
NOTE:
This face has an adjustable bracket that allows for
different facing depths to be tucked under the face.
36”
29”

564 Rectangular Face
Black 95400411 Nickel 95400413
Page 2 of 4 17601478 4/1/16 © Travis Industries, Inc.
Installation
1 Remove the glass frame (see the owner's manual for details). Install face mounting brackets to the fireplae..
Repeat these steps for the opposite side.
Upper
Bracket
Lower
Bracket
Remove the nuts and bushings above and
below the firebox. Place the brackets into
position then replace the bushings and nuts
to secure the brackets in place.
Upper
Left
Lower
Left
Upper
Right
Lower
Right

564 Rectangular Face
Black 95400411 Nickel 95400413
Page 3 of 4 17601478 4/1/16 © Travis Industries, Inc.
Installation (continued)
2 The facing and hearth (if applicable) must be installed prior to attaching the face. See the installation
manual for complete details.
Raised
Fireplaces
























































Note how the tile is 1”
(maximum) above the
base of the fireplace.




















































Maximum 1`” Hearth
Floor-Level
Fireplaces





564 Rectangular Face
Black 95400411 Nickel 95400413
Page 4 of 4 17601478 4/1/16 © Travis Industries, Inc.
Installation (continued)
3 Install the face following the directions below.


























































Attach the upper brackets
to the face with the
included nuts.
Slide the face into place. The
tabs on the upper brackets insert
into the slots on the fireplace
brackets, holding the face in place
while the screws are tightened.
a
b
cThe face is secured to the fireplace
with four screws. Two of the screws
are fastened to the upper brackets
with press nuts. The lower screws
are included with the face.
Plated Surfaces
Use denatured alcohol and a soft cloth to clean plated surfaces. Marks
left on the surface may damage the face.
Denatured
Alcohol
Soft Cloth