FireplaceXtrordinair 4237 User manual

Trim Installation (4237)
Page 1 of 3 17601944 - 5/4/21 Travis Industries, Inc.
Trim SKU’s
Current SKU’s Discontinued SKU’s
Beveled Trim 95900352 Ironworks Bronze 95900516
2” Rectangular Trim 95900354
Ironworks Charcoal 95900515
Sizing
Width Height* Trim Size
Beveled Trim 44-3/4” 38-1/4” 1/2"
2” Rectangular Trim 47-3/4” 39-3/4” 2”
Ironworks Trim 47-3/4” 39-3/4” 2”
* The bottom of the trim, when installed, is 1” above the base of the fireplace.
Minimum Facing Depth Maximum Facing Depth
All Trim 1/2” 1”
Cross Section of Trim
Beveled 2” Rectangular Ironworks
Packing List
Left, Right, and Top Trim
(18) #8 x 3/8” Pan Head Screws
Ironworks Trim
(2) ¼ x 20 Flat Head Screw (1/2”)
5/32” Hex Wrench
Beveled Trim
(2) L Brackets with 2 Set Screws Pre-Installed
(2) L Spacers
2” Trim
(4) L Brackets with 2 Set Screws Pre-Installed
(4) L Spacers

Trim Installation (4237)
Page 2 of 3 17601944 - 5/4/21 Travis Industries, Inc.
Installation
NOTE: The trim replaces the tile stop on the fireplace (if installed, remove and discard the tile stop).
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1 The trim is attached after the fireplace is in place with the non-combustible facing installed.
2 Remove the glass screen (and appliance trim) from the fireplace (see the manual for details).
3 Assemble the trim (see instructions below)
IronWorks Trim
Attach the trim to the top trim with the included ¼-20 screws (see photo below). The trim has a left and right side,
make sure to use the correct side when assembling the trim.
Beveled and 2” Trim
Assemble the trim kit as shown below. Use one L bracket and spacer for each corner (use two brackets and two
spacers for the 2” trim). Use a screwdriver to tighten the set screws from behind. If the corners are not aligned,
loosen the screws, align, and re-tighten.
HINT: Blacken the Edges of the Extruded Trim
Before constructing the trim assembly, use a black permanent marker to blacken the silver edges of the extruded trim.

Trim Installation (4237)
Page 3 of 3 17601944 - 5/4/21 Travis Industries, Inc.
4 Place the trim in place, taking care to not scratch the surfaces. Once it is fully in place, use the included
screws to secure the trim to the fireplace. When tightening the screws, push the trim against the facing to
ensure a seamless fit.
5 Restore the fireplace to the correct configuration.