Fisher & Paykel DE60F60NW1 Mounting instructions

AU
Installation instructions
and User guide
Condenser dryer
DE60F60NW1 model

1
Contents
Safety and warnings 2
Installation instructions 4
Before drying 6
Selecting a programme and operating your machine 7
Maintenance and cleaning 12
Troubleshooting 14
Manufacturer’s Warranty 16
Customer Care 17
Important!
SAVE THESE INSTRUCTIONS
The models shown in this User Guide may not be available in all markets and are
subject to change at any time. For current details about model and specification
availability in your country, please visit our local website listed on the back cover
or contact your local Fisher & Paykel dealer.
Caution, risk of fire – this is a safety symbol.
Failure to follow the warnings outlined in these user instructions can cause
a fire hazard.

2Safety and warnings
WARNING!
Fire Hazard
Please read the following information. Otherwise, there may be the
risk of personal injury or material damage. Moreover, any warranty
and reliability commitment will become void.
General safety
Never place your machine on a carpet covered floor. The lack of airflow from below your
machine may cause electrical parts to overheat.
Your machine is designed to stop operating in the event of power resuming after a power failure.
You must press START/PAUSE/CANCEL button to resume the programme.
Press the START/PAUSE/CANCEL button for 3 seconds to cancel the programme (see, ‘Ending the
programme through cancelling’ page 11).
Your machine can be operated at temperatures between +5°C and +35°C.
This appliance is not intended for use by persons (including young children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision on instruction concerning the use of the appliance by a person
responsible for their safety.
First use
When operating your machine for the first time, partly load it with wet items of clothing and let
it run approximately for 15 minutes.
You may smell an unpleasant odour and excessive fibre/lint may accumulate during first
drying cycle.
For safety and performance purposes, clean the filters after each drying cycle.
Intended use
This product has been designed for home use.
The appliance may only be used for drying textiles that are marked accordingly.
Do not operate this product without the lint filter in place.
Do not dry unwashed items in the dryer.
Safety instructions
Unplug the machine when it is not in use.
Never wash down the appliance with water. There is the risk of electric shock!
Never touch the plug with wet hands.
Never pull from the cable to unplug the machine.
Do not operate the machine if the power cord or plug is damaged.
Never attempt to repair the machine yourself.
For malfunctions that cannot be solved by information in the User Guide:
Turn off and unplug the appliance and contact a Fisher & Paykel Authorised Repairer.
Lint must not be allowed to accumulate around the tumble dryer.

3
To minimise the risk of fire in a tumble dryer, the following should be observed:
Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol,
kerosene, dry cleaning solvents, spot removers, turpentine, waxes or wax removers, should be
washed in hot water with an extra amount of detergent before being dried in the tumble dryer.
Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as
in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation
creates heat. If the heat cannot escape, the items can become hot enough to catch fire. Piling,
stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard.
If it is unavoidable that fabrics that contain vegetable or cooking oil or have been contaminated
by hair care products be placed in a tumble dryer they should first be washed in hot water with
extra detergent - this will reduce, but not eliminate, the hazard.
The ‘cool down’ cycle of tumble dryers should be used to reduce the temperature of the items to
ensure they will not be damaged. They should not be removed from the tumble dryer or piled or
stacked while hot.
Important!
Never stop the tumble dryer before the end of the drying cycle unless all items are quickly
removed and spread out so that the heat can dissipate.
The dryer should not be used for items cleaned using industrial chemicals.
Items containing foam rubber (also known as latex foam) or similarly textured rubber like
materials should not be dried in a tumble dryer.
Foam rubber materials can, when heated, produce fire by spontaneous combustion.
Fabric softeners or similar products should not be used in a tumble dryer to eliminate the effects
of static electricity unless this practice is specifically recommended by the manufacturer of the
fabric softener or product.
Undergarments that contain metal reinforcements should not be placed in a tumble dryer.
Damage to the tumble dryer can result if metal reinforcements come loose during drying.
Plastic articles such as shower caps and waterproof textiles should not be placed in a tumble
dryer.
Rubber-backed articles, fibreglass, clothes fitted with foam rubber pads, pillows, galoshes and
rubber-coated tennis shoes should not be placed in a tumble dryer.
If there are children in your house...
Electrical appliances may be dangerous for children. Keep children away from the machine when
it is operating. Do not let them tamper with the machine.
Close the loading door when you leave the area where the machine is located.
Young children should be supervised to ensure that they do not play with the appliance.
Safety and warnings

4
The proper location
Install your machine in environments which have no risk of freezing and in a stable and level
position.
Do not install the machine behind lockable door, a sliding door, or a door that is hinged on the
opposite side to that of the dryer, in such a way that the door of the machine cannot be opened fully.
Do not place your machine on a carpet covered floor, a long pile rug or on similar surfaces.
Operate your machine in a well ventilated, dust-free environment.
Make sure that your machine is not placed on the power cable.
Place it at least 30 mm away from the edges of other furniture and walls.
Place the machine on a sound floor.
A special part (Part No. 791746) must be used if the machine is to be installed under a counter or
in a cupboard. This replaces the top trim and must be installed by a Fisher & Paykel Authorised
Repairer. Never operate the machine without the top trim.
If the machine is to be placed on top of a washing machine, the approximate weight together
may reach 180 kg when they are full.
A stacking kit should be used between the products, fitted to the washing machine.
Stacking Kit White Part No. 790691
Levelling
In order to ensure that your machine operates quietly and vibration-free, it must stand level and
balanced on its feet.
Balance the machine by adjusting the front feet. Loosen the feet by hand, and adjust them until
the machine stands level and does not rock.
Never unscrew the adjustable feet from their housings.
Two plastic pieces supplied with the Installation Instructions and User Guide
prevent your machine from slipping on wet and slippery surfaces. Tilt your
machine backwards to install these plastic parts. Fit the plastic parts to the
front adjustable feet. Press on the plastic parts to fix them in their places. Check
the balance of your machine again and readjust the adjustable feet if necessary.
Installation instructions
Fig.1 Fitting the
non-slip foot caps
Technical specifications
Specification
Height / Height for built-under installation (mm) 850 / 820
Width (mm) 595
Depth / Depth for built-under installation (mm) 540
Height adjustment of feet (mm) 5
Length of drain hose (mm) 1400
Diameter of drain hose (mm) 10
Highest point of the hose (mm) 800
Weight, unpacked 36
Voltage 220 – 240V, 50 Hz
Connected load 2000 – 2200 W
Fuse protection 16A

5
Electrical connection
Connect the machine to an earthed outlet protected by a fuse of suitable capacity.
Important!
 Connection should comply with national regulations.
 Power cord plug must be within easy reach after installation.
 The voltage and the allowed fuse protection are specified in the section ‘Technical specifications’
(page 4).
 The stated voltage must match with your mains voltage.
 Connection via extension cords or multi-plugs should not be made.
 The main fuse and switches must have a contact distance of minimum 3 mm.
 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
 The appliance must not be operated unless it is repaired! There is the risk of electric shock!
Products equipped with a condenser unit accumulate water during the drying cycle, which is
collected in the water tank. The accumulated water should be drained after each drying cycle.
Connection to a water drain
The TANK FULL warning LED will light up at the end of
each programme.
You can directly send the accumulated water out
through the water drain hose supplied with the machine
instead of periodically draining the water collected in
the water tank.
Connecting the water drain hose:
1
Remove the hose on the machine by pulling it out from
its end. Do not use any tools to take out the hose.
Attach the drain hose adaptor to the end of this hose.
2
Connect the special drain hose supplied with the
machine to the hose adaptor fitting.
3
The other end of the drain hose can be directly
connected to the wastewater drain or to the washbasin.
The fitting must always be secured in all types of
connections. Your house may be flooded if the hose gets
out of its housing during water discharge.
Important!

The hose should be attached to a maximum height of 800 mm.

You must be careful not the pinch or bend the hose.

The end of the hose should not be bent, it should not be stepped on and it must not be folded
between the drain and the machine.
Installation instructions
Fig.2 Connecting to a water drain

6Before drying
Always follow the advice on the garment labels. With this dryer, dry only items where the label
states that they are suitable for drying in a dryer by selecting the appropriate programme.
Laundry items with metal attachments such as belt buckles and metal buttons can damage
your machine.
Do not dry items such as woollen, silk garments and nylon stockings, delicate embroidered
fabrics, garments with metal accessories and items such as sleeping bags in the machine.
Garments made of delicate and valuable fabrics as well as lace curtains can be creased. Do not
dry these in your machine!
Do not dry items made of hermetic fibres such as pillows and quilts in the dryer.
Do not dry clothes containing rubber in the machine.
Do not dry clothes which have been exposed to petroleum, oil, combustible or explosive agents
in the machine even if they are washed beforehand.
Overly wet laundry or laundry that is dripping water must not be put into the machine.
Preparing clothes to be dried
All laundry must be spun at the highest possible spin speed your washing machine allows for the
textile type.
Laundry may be tangled after washing. Separate items before placing them into your dryer.
Sort your laundry according to their types and thicknesses. Dry the same kinds of items together.
Correct load capacity
The maximum capacity of the dryer is 6 kg.
Adding laundry to the machine more than the level shown in Fig.4 is
not recommended.
The drying performance of the product will decrease when the machine
is overloaded.
Overloading may also cause damage to the product and your clothes.
Place your garments into the drum loosely so that they will not get tangled.
Large pieces may bunch-up during drying. Stop the machine 1 – 2 times
during the drying process to separate bunched-up laundry.
Loading door
Open the loading door. Place laundry items loosely into the machine. Push the loading door to
close. Ensure that no items are caught in the door.
Fig.3 Garment care indicators
Fig.4 Loading the laundry

7
Selecting a programme and operating your machine
Control panel
Turning the machine on
Prepare the machine for programme selection by pressing the ON/OFF button.
Pressing the ON/OFF button does not necessarily mean the programme has started.
Press the START/PAUSE/CANCEL button to allow the machine to start the programme.
Programme selection
Choose the appropriate programme from the table below. Select the desired programme with
the programme selection button.
Extra dry
Dry at high temperature only for cotton laundry. Thick and multi-layered
laundry (eg: towels, linens, jeans) are dried in a way that they do not
require ironing.
Ready to Wear
Normal laundry (eg: tablecloths, underwear) are dried in a way that they
do not require ironing before placing in drawers.
Ready to Iron Normal laundry (eg: shirts, dresses) are dried ready to be ironed.
Always select the highest temperature that is safe for the type of items in the load (check care
labels). A higher temperature will ensure energy and time saving, but may be unsuitable for
some items and cause damage.
1
ON/OFF button
2
Programme selection knob
3
START/PAUSE/CANCEL button
4
Cancel Audio Warning
5
Programme follow-up indicator
6
CLEAN FILTER warning LED
7
TANK FULL warning LED
Fig.5 Control panel features
123456
7

8Selecting a programme and operating your machine
Main programmes
Depending on the type of textile, the following main programmes are available:
Cottons
You can dry your durable clothes with this programme as it dries at a higher temperature.
It is recommended to use for your cotton items (such as bed sheets, quilt cover,
underclothing, etc).
Synthetics
You can dry your less durable clothes with this programme, as it dries at a lower temperature
compared to the cottons programme. It is recommended for your synthetic clothes (such as
shirts, blouses, synthetic/cotton blended garments, etc).
Do not dry curtains and lace in your machine.
Wrinkle Guard
A two-hour WRINKLE GUARD programme to prevent laundry from creasing will be activated if you
do not take the laundry out after the programme has come to an end. This programme rotates
the laundry in 60-second intervals to prevent creasing.
Delicates
A lower temperature for your very delicate laundry (silk blouses, fine underwear, etc) that is
suitable for tumble drying or laundry which is recommended to be hand-washed.
Freshen up
This 10 minute airing cycle blows cool air through your clothes. It is used to freshen clothes and
deodorise unpleasant odours on items that have been kept in closed environments for long
periods.
Timed programmes
Select one of the 10 min, 20 min, 40 min and 60 min timed programmes to achieve the desired
final drying level at low temperatures. The machine dries for the selected time regardless of
the level of moisture in your clothes. It is important to check the clothes throughout the longer
timed programmes to avoid overdrying.