Fisher & Paykel OB60SC6LEB User manual

BUILT-IN OVEN
INSTALLATION GUIDE
NZ AU
CONTEMPORARY
OB60SC5LB, OB60SC6LEB & OB60SC7LEB

2
!WARNING!
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
z Before carrying out any work on the electrical
section of the appliance, it must be disconnected
from the mains electricity supply.
z Connection to a good earth wiring system is
absolutely essential and mandatory.
z Alterations to the domestic wiring system must
only be made by a qualified electrician.
!WARNING!
Fire Hazard
Failure to follow this advice may result in
overheating, burning, and injury.
z Do not use adapters, reducers, or branching
devices to connect this appliance to the mains
power supply.
!WARNING!
Cut Hazard
Failure to use caution could result in injury.
z Take care: some edges are sharp.
READ AND SAVE THIS GUIDE
WARNING!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
z Please make this information available to the person installing the appliance—doing so
could reduce your installation costs.
z This appliance must be installed and connected to the mains power supply only by a
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
z If the power supply cable is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person in order to avoid a hazard.
z Isolating switch: make sure this oven is connected to a circuit which incorporates an
isolating switch providing full disconnection from the power supply in accordance with the
wiring rules.
z The oven must be earthed.
z Do not use adaptors, reducers or branching devices to connect the oven to the mains
electricity supply, as they can cause overheating and burning.
z The appliance must not be installed behind a decorative door in order to avoid
overheating.
z Please take extra care not to damage the lower trim of the oven during installation. The
trim is important for correct air circulation and allows the door to open and close without
obstruction. The manufacturer does not accept any responsibility for damage resulting
from incorrect installation.
SAFETY AND WARNINGS

3
Screws (2) Metal side shelves
fixing nut (2)
Before installation, please ensure the following:
z The countertop and oven cavity are square and level, and are the required dimensions.
z The installation will comply with all clearance requirements and applicable standards and
regulations.
z The isolating switch will be easily accessible to the customer with the oven installed.
z The electrician provides sufficient free length of power supply cable to reach from the
bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening.
z The cable may enter the cavity from the side, top or bottom, but top entry must be at the
rear of the cavity.
z The oven connection socket (if fitted) is outside the cavity if the oven is flush to the
rear wall.
z The oven will rest on a surface that can support its weight.
z The height from the floor suits the customer.
z You consult local building authorities and by-laws if in doubt regarding installation.
Some environmental factors and cooking habits can cause condensation in and around the
oven during use. To protect surrounding cabinetry from possible damage caused by frequent
or excessive condensation, we recommend moisture-proofing the oven cavity.
During installation, please ensure the following:
z The oven door can open fully without obstruction.
z The power supply cable does not touch any hot metal parts.
z The isolating switch is easily accessible to the customer with the oven installed.
z You complete the ‘Final checklist’ at the end of the installation.
z If, after following the instructions given, correct performance cannot be achieved, please
contact your Fisher & Paykel trained and supported service technican or Customer Care.
INSTALLATION CONSIDERATIONS COMPONENTS REQUIRED
PARTS SUPPLIED
TOOLS REQUIRED
Crosshead
screwdriver
Power drill Scissors

4
PRODUCT DIMENSIONS
a
c
f
g
d
e
h
FRONT
PLAN
PROFILE
Actual product dimension may vary by ± 2 mm.
b
PRODUCT DIMENSIONS MM
A Overall height of oven 598
B Overall width of oven 596
C Overall depth of oven (excluding handle and dials) 565
D Height of chassis 575
E Width of chassis 556
F Depth of chassis 545
G Depth of oven frame and control panel
(distance between front of chassis and front of oven door, excl. handle and dials) 20
H Depth of oven door when fully open
(measured from front of control panel) 450

5
CABINETRY DIMENSIONS
PROUD INSTALL
FLUSH INSTALL
16-20mm
16-20mm
2mm
PROFILE PLAN
eb
a
c d
Actual product dimension may vary by ± 2 mm.
CABINETRY DIMENSIONS MM
A Minimum inside width of cavity 560
B Overall width of cabinetry 600
C Minimum inside height of cavity 580
D Overall height of cabinetry 600
E Minimum inside depth of cavity 550
If installing a cooktop above the oven, ensure adequate clearance is provided as per the cooktop manufacturer’s instructions.

6
Remove the accessories box from
the top of the oven and set aside.
Recycle responsibly
L1N(L2) E
L1N(L2) E
Brown (Live)
Blue (Neutral)
Green & Yellow (Earth)
Ensure cable
clamp is
tightened
Unclip
and lift
SECURE THE OVEN TO THE CABINETRY
z Do not lift the oven by the door handle.
z Do not over-tighten the screws.
z Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing
difficult. Fisher & Paykel will not cover the costs of removing the oven, or of damage
caused by this removal.
1 Position the oven in the prepared cavity.
2 Open the oven door fully.
3 Mark and pre-drill the screw holes.
4 Use the supplied screws to secure the oven to the cabinetry.
Before connecting the oven to the mains power supply, check that:
the domestic wiring system is suitable for the power drawn by the oven (as specified on the
rating plate) the voltage corresponds to the value given on the rating plate.
MODEL CODE MAX POWER (W) HZ VOLTAGE (V) AMPS (A)
OB60SC 2700 – 3100 50 – 60Hz 220 – 240V~ 12.0 – 13.0
DISCARD PACKAGING RESPONSIBLY
ELECTRICAL CONNECTION

7
INSTALLER CHECKLIST
Read all installation guidance in this document to see if the unit has been correctly installed.
Ensure that installation has been completed correctly before use.
TO BE COMPLETED BY THE INSTALLER
Ensure the oven is level and securely fitted to the cabinetry.
Open the oven door slowly until it is fully open and check there is adequate
clearance between the bottom of the door and the cabinetry.
This is to ensure correct air circulation. Should the lower trim become damaged,
straighten the trim and ensure the oven door opens fully without obstruction.
Ensure you remove all internal packaging (including the circular yellow packing
retainers holding the accessory box in place).
Ensure all oven vents and openings are clear and free of any obstruction or damage.
Failure to ensure all oven vents are clear may result in poor product performance.
Ensure the isolating switch is accessible by the customer.
Turn the power to the oven on. The display should light up.
Set the clock following the instructions in the user guide.
Set the oven to Bake at 50°C. The light should come on inside the oven cavity and air
should blow out of the vent at the top of the oven. After five minutes, open the oven
door: the air inside should feel warm. Turn the oven off.
Have you demonstrated the basic operation to the customer?
Complete and keep for safe reference:
Model
Serial No.
Purchase Date
Purchaser
Dealer Address
Installer’s Name
Installer’s Signature
Installation Company
Installation Date

866261A 09.20
FISHERPAYKEL.COM
© Fisher & Paykel Appliances 2020. All rights reserved.
The models shown in this guide may not be available in all markets
and are subject to change at any time.
The product specifications in this guide apply to the specific products and
models described at the date of issue. Under our policy of continuous product
improvement, these specifications may change at any time.
For current details about model and specification availability in your country,
please go to our website or contact your local Fisher&Paykel dealer.