Fisher-Price HGB82 User manual

HGB82

2
Where great minds think like kids™
Since 1961, early childhood development experts at the Fisher-Price™Play Lab have
watched and learned from real-life fun experts (aka babies & big kids) to help us design
toys and nursery gear that help babies learn and grow in the most natural way. From
bright colors that delight their eyes and textures made for squishing, to friends that
keep tummy time exciting, Fisher-Price®toys are made just right for your newborn.

3
Battery Installation
Use
1,5V x 3
AA (LR6)
For longer life, use alkaline batteries.
Locate the battery compartment
door on the back of the
electronic toy.
Loosen the screw in the battery
compartment door and remove
the door.
Insert three, new AA (LR6)
alkaline batteries.
Replace the battery compartment
door and tighten the screw.
Do not over-tighten.
If this product begins to operate
erratically, you may need to
reset the electronics. Slide the
power-volume switch off and
then back on.
When sounds or lights become
faint or stop, it’s time for an adult
to change the batteries.
Consumer Information
Keep this instruction sheet for future reference, as it contains important information.
Adult assembly is required.
Requires three AA batteries (not included).
Tool required for battery installation: Phillips screwdriver (not included).
Slide the power-volume switch to ON with low volume ,
ON with high volume or OFF .
Slide the mode switch on the electronic toy to short play
mode or long play mode.
In short play mode , press the button or rock the electronic
toy for lights, sounds, and songs. Press the button again to
advance to the next song.
In long play mode , press the button on the electronic toy
to start approx. 20 minutes of lights and music. Press and
hold the button for two seconds to stop all functions.

4
Parts
Bases Supports
Care
The mat and soft toy are machine washable. Wash separately in cold water on
the gentle cycle. Do not use bleach. Tumble dry on low heat.
The arches, teether, rattle, mirror, bases, supports and electronic toy can be
wiped with a clean, damp cloth. Do not immerse the electronic toy.
The supports are
packaged inside
of the bases for
storage purposes.
The supports are
only used with
Crawl-Through
Cottage.

5
Lay & Play Setup
2
1
Fit the straps on the mat into
the slots in the bases. Make
sure the tab on the end of
each strap forms a "T" on the
other side of the slot.
Pull up on the mat to be sure
it is assembled to the bases.
Connect the upper ends of the arches together. Repeat for the other
set of arches. If arches do not seem to fit together, pick up another arch
and try again.

6
To prevent entanglement injury,
never place the gym in a crib or
playpen. Never add strings, ties
or other products to the gym.
WARNING
3
4
Lay & Play Setup

7
1
2
Tummy Time Setup
Thread the arch through the
shorter sleeves on the mat.

8
3
Tummy Time Setup
Fit the ends of the arch into
the socket of each base.
4

9
2
1
Crawl-Through Cottage Setup
Press the latch and pull to disconnect the arches. Repeat for the other
set of arches.

10
3
4
Crawl-Through Cottage Setup
Remove the supports from
underneath the bases.
Fit the bases onto the
supports.