TROUBLESHOOTING GUIDE
BATTERY INFORMATION
Keep these instructions for future reference
as they contain important information.
DKV68-0970
1100855686-DOM
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire
de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre son fonctionnement.
© 2016 Viacom International Inc.
All Rights Reserved.
Nickelodeon, Blaze and the Monster Machines
and all related titles, logos and characters are
trademarks of Viacom International Inc.
©2016 Mattel. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel,
except as noted.
PRINTED IN CHINA.
Mattel East Asia Ltd., Room 503-09, North
Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China. Tel.: (852) 3185-6500.
SYMPTOM SOLUTION
Vehicle drives
slowly or does
not perform
properly
Vehicle does
not respond
to the R/C wrist
controller
• The wheels on the Vehicle may be dirty. Wipe them with a clean cloth.
• Reset the electronics by turning the ON (I)/OFF (O) switch to OFF (O)
and then ON (I) again.
• Battery power in the Vehicle may be weak. Replace all FOUR batteries
in the Vehicle with fresh, alkaline batteries.
• Re-start the Vehicle by pressing the button on Blaze’s hood.
• Battery power in the R/C wrist controller or in the Vehicle may be weak.
Replace TWO batteries in R/C wrist controller and FOUR batteries in the
Vehicle with fresh, alkaline batteries.
• You may be beyond the maximum range (16 feet/5 meters) of the R/C
wrist controller. Move the R/C wrist controller closer to the Vehicle.
• You may not have a clear path between the Vehicle and the R/C wrist
controller. This toy works best when there are no obstructions between
the Vehicle and the R/C wrist controller.
• Try dimming the lights in the room. Bright sunlight or uorescent lights
may aect the range of the R/C wrist controller.
Protect the environment by not disposing
of this product with household waste
(2012/16/EU). Check your local authority
for recycling advice and facilities.
BATTERY INSTALLATION
• Unscrew and lift covers away from bottom of
Blaze and back of R/C wrist controller.
• Install batteries as indicated inside the
battery compartments.
• For longer life use only alkaline batteries. If
the product begins to malfunction, check the
battery installation.
• You may need to reset the electronics by
removing the batteries and reinstalling them.
• If the product continues to malfunction or no
longer operates, remove the batteries from
the toy and replace them with fresh batteries.
• Requires 4 “AA” (LR6) alkaline batteries for
Blaze and 2 “AAA” (LR03) alkaline batteries for
R/C controller .
BLAZE R/C WRIST CONTROLLER
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could
void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Required tool:
Phillips screwdriver
(not included)
1,5V x 4
“AA” (LR6)
1,5V x 2
“AAA” (LR03)
