Fisher-Price Switch Board 72889 User manual

®
Switch BoardTM
Instructions
Product Number: 72889
Please save these instructions for future reference.
No assembly is required.
Adult assistance is required to adjust the handle up or down.
Ages 5 years and up.
Weight limit: 100 lbs (45 kg).

To prevent injury:
• Keep away from cars and streets.
• Always wear protective equipment including helmet, wrist
guards, knee pads and elbow pads.
IMPORTANT! Please take a few moments to review the following
safety tips with your rider.
• Your rider should wear shoes or sneakers that provide good support.
• Your rider should not wear open-toe shoes.
• Your rider should wear a helmet, knee pads, wrist guards and elbow pads
to guard against bumps and bruises.
• Keep loose laces and pant legs away from the wheels.
• Supervise beginners. Hold the beginner’s hand and guide the new rider
along a smooth, level surface.
• Choose areas for riding that are free of obstacles, and avoid wet or
uneven surfaces.
• Make sure your rider never rides on streets, roadways and driveways which
enter vehicle traffic routes.
• Towing riders with bicycles or cars is unsafe.
2
WARNING

The Switch Board
™
trucks are adjusted at the factory to the stiffest
setting (for beginner use).The stiff setting provides the greatest stability.
As your child becomes more comfortable and is better able to balance on
Switch Board
™
, you can adjust the trucks (to a loose setting) to allow
greater steering control.
Counter-Clockwise
for Loose Setting
• Turn Switch Board™upside-down
on a flat surface. Locate both trucks
(on each end).
Hint: Be sure to place a sheet or
towel on the surface to protect it.
• Using an adjustable wrench:
-Turn each nut clockwise for a
stiff setting.
-Turn each nut counter-clockwise
for a loose setting.
Hint: You should not need to loosen
the nut more than a few turns for a
loose setting.
IMPORTANT! Check to be sure you
have not loosened the trucks too
much! Pull on both trucks.The trucks
should remain on Switch Board™.If
you can remove either of them, you
have loosened the truck(s) too much.
Replace the truck(s) and tighten
the nut(s) clockwise with an adjust-
able wrench.
3
Adjusting the Trucks
Truck
Clockwise for
Stiff Setting

• Place Switch Board™on its side with the handle facing up.
• Squeeze the sides of the handle latch and pull it out completely. While
holding the handle latch out with one hand, pull the handle outward slightly
(about two inches) with the other hand. Release the handle latch .
• Continue to rotate the handle to the upright position.
•Push the handle latch until the tabs “snap” into place and . Make
sure you hear a “snap”.
• Position Switch Board™upright. Push the handle back to be sure it
is secure.
Hint: Make sure your rider stands on the middle of the target for balance!
Scooter
Note: Protective equipment in
this illustration is not included
with this toy.
Handle Up
Handle
Handle Latch
Stand on Target for Balance
4
Tabs
Handle Latch
Handle Latch
Handle Up
12
3
1
2 3
PUSH

Stand on Target for Balance
• Place Switch Board™on its side with the handle facing up.
• Squeeze the sides of the handle latch and pull it out completely. While
holding the handle latch out with one hand, pull the handle down slightly
(about two inches) with the other hand. Release the handle latch .
• Continue to rotate the handle completely down.
•Push the handle latch until the tabs “snap” into place and . Make
sure you hear a “snap”.
• Position Switch Board™upright. Pull the handle up to be sure it is secure.
Hint: Make sure your rider stands on the middle of the target for balance!
Handle
Handle Latch
5
Skateboard
Handle Down
Note: Protective equipment in
this illustration is not included
with this toy.
Handle Down
1
1
23
Tabs
Handle Latch
Handle Latch
2
3
PUSH

If you have any questions about this product:
In Canada, call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2
In Great Britain, telephone [phone].
In Australia, call the Consumer Advisory Service at 1-800-800-812 (valid only in Australia), or write to: Mattel Australia Pty.,
Ltd., 658 Church Street, Locked Bag #870, Richmond Victoria 3121 Australia.
6
Questions?
We’d like to hear from you!
Call Fisher-Price®Consumer Affairs, toll-free at 1-800-432-KIDS,
8 AM - 5 PM EST Monday through Friday. Hearing-impaired consumers using
TTY/TDD equipment, please call 1-800-382-7470. Or, write to: Fisher-Price®
Consumer Affairs, 636 Girard Avenue, East Aurora, NewYork 14052.
• Periodically inspect Switch Board™for wear or damage. Check all nuts and
bolts and tighten as required.
• To clean, use a mild soap and water solution and clean cloth. Rinse clean
with water to remove soap residue.
• This product has no consumer serviceable parts. Please do not take this
product apart.
Care
Consumer Information
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©1999 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S.trademarks of Mattel, Inc.
Printed in China 72889pr-0920