Ignite ESK02 User manual

CAUTION: Please read the operating instructions before riding.
Any child must be accompanied by an adult while using this
skateboard. In Australia, each state and territory has specic
regulations that may apply to this product, including where
you can legally use such products and if you need to register
them with your local road trafc authority. Please be sure to
familiarise yourself with these prior to using this product.
ESK02
ELECTRIC SKATEBOARD
USER MANUAL

ESK03 3
PRODUCT OVERVIEW
SKATEBOARD &
CONTROLLER PAIRING
CHARGER
REMOVABLE BATTERY
SPECIFICATIONS
SAFETY INSTRUCTIONS
WARRANTY
04
05
05
06
07
08
08
POWER BEYOND

ESK03 5
SKATEBOARD & CONTROLLER PAIRING
CHARGER
PRODUCT OVERVIEW
1
4
6
2
5
3
9
10
11 12
14
17
13
15
16
7
8
# ACCESSORY/ PART # ACCESSORY/ PART
1Front Truck 10 Speed Mode (Hi/Med/Low)
2LED light 11 Directional Mode (Forward/Back)
3Battery Housing 12 Power Button
4USB Hub 13 Signal Indicator
5Battery Indicator Button 14 Skateboard Battery Indicator
6Charging Port 15 Remote Battery Indicator
7Power Button 16 Pair Button
8Hub Motor 17 Charging Port
9Speed Control
Before riding the Skateboard and Remote must be paired together. Ensure both
Skateboard and Remote are turned off. Then follow the pairing procedure below.
Red Light: Skateboard is charging
Green Light: Skateboard is fully charged.
1. Turn on the board
2. Press the power button for 5 seconds, then the power button light will ash.
3. Turn on the remote, then press the pair button. The signal indicator will ash
and the power button light will ash with same frequence. Then means the two
products are paired successfully.
4. Roll the speed control forward to test the accelaration and backward to test the
brake. After tested all function work normal you can start your riding.
1 3

ESK03 7
1 2
SPECIFICATIONS
ACCESSORY/ PART DETAILS
Model ESK02
Deck Construction Maple
Max Speed
Low Setting 15km/h
Medium Setting 20km/h
High Setting 25km/h
Rider Weight Max: 100kg
Dimensions L820 x W260 x H160mm
Battery
Type Samsung Cell
Rated capacity 4.4Ah
Charging Time ~4 Hours
Motor
Type 75mm Hub Motor
Power 350W*2
Wheel
Material Polyurethane
Size Dia75 x W51mm
Remote
Distance 14m
Frequency 2.4GHz
Charging Time 2 Hours
Weight
Net Weight 6.0 kg
Gross Weight 7.9 kg
[1] ITEM HEIGHT: from the ground to the top of the scooter;
[2] DISTANCE RANGE: measured when it is no wind and at 30°C, the skateboards fully charged to ride at a even speed of
20km/h on a at surface with a load of 75kg.
REMOVABLE BATTERY
1. Using your index nger to push the bulge on the side of the battery pack.
2. With you other hand, use your index nger & thumb as shown to press down
on the hook.
3. Using both hands, slide the battery pack from the housing case.
4. The battery is now free and can be replaced.
NOTE: When travelling futher distances it is recommended to travel with 2 or more
battery packs. The battery can double up as power bank when seperated from
the Skateboard.
3 4

ESK03 8
SAFETY INSTRUCTIONS
1. In Australia, each state and territory has specic regulations that may apply to this
product, including where you can legally use such products and if you need to register
them with your local road trafc authority. Please be sure to familiarise yourself with
these prior to using this product.
2. The ESK02 electric skateboard is not a toy, should be treated with appropriate caution.
Ensure that you use the board in a safe & appropriate environment, and always wear
the required safety gear outline in point 3 below.
3. Safety Gear: It is required that full safety gear is worn when operating this skateboard.
An Australian standard skateboard helmet, elbow pads, knee pads, and gloves are all
required before riding.
4. Appropriate footwear: Flipops/Thongs/Jandals or any open toe footwear are not
suitable when in operating this skateboard.
5. This skateboard is designed for anyone over 10 years old. Children under the age
of 16 must be accompanied by an adult when opperating this skateboard.
6. This skateboard is designed to carry one rider only, it is engineered to support a
maximum weight capacity of 100kg.
7. The board is designed to drive on at and paved surfaces. Avoid driving on sand,
gravel, mud, rugged or open ground. Do not drive on slippery ground, such as snow,
ice or oil.
8. Keep ngers, hairs, and clothing away from motors, wheels and any moving parts.
9. Do not open, modify or tamper with battery housing.
Aquilia Group Pty Ltd. shall not be liable for any nancial losses, physical injuries,
accidents, legal disputes and other interest conicts resulted from actions that violate
the user instruction manual.
PRODUCT WARRANTY
This product & controller is covered under warranty for regular use for 12 months.
NOTE: Please use this skateboard appropriately, any damage caused by abnormal use
will not be covered under the standard warranty, this inlcudes:
a. If the skateboard is not properly maintained and repaired per the instruction manual.
b. The use of the ESK03 Skateboard in stunts or at skate parks that results in
damage or malfunction.
c. Any disassembly, modications, or repairs using non-factory parts.
d. Incomplete label or part number mismatch.
e. Commercial rental.
f. Injury caused by mistakes, trafc accidents, or accidental collisions.
g. Storing the skateboard in direct sunlight.
h. Submerging the skateboard submerged in more than 5cm of water.