Flash F7100518 User manual

LED MOVING HEAD BEAM 80W
User Manual
Instrukcja Obsługi
F7100518

User Manual •Instrukcja Obsługi
Please keep this User Manual for future
another user, be sure that they also receive
this instruction booklet.
Unpack and check carefully there is no
transportation damage before using the
Before operating, ensure that the voltage
and frequency of power supply match the
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing
and maintenance.
only, but always by taking its base.
Don’t operate it where the temperature is
higher than this.
replaced if they are visibly damaged.
In the event of serious operating problem,
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare
parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation
and there might be a hazard of electric
shock.
To prevent or reduce the risk of electrical
rain or moisture.
visibly damaged.
Do not look directly at the LED light
2. SAFETY INFORMATION
1. INTRODUCTION
MOVING HEAD BEAM 80W
WARNING!

LED MOVING HEAD BEAM 80W •Art No F7100518
11 and 13 DMX channels
holes on the bracket. Always ensure that
and slipping while operating. Always
ensure that the structure to which you are
attaching the unit is secure and is able to
5.1 Connecting DMX signal
4. INSTALLATION
5. CONNECTION
3. PRODUCT INFORMATION
weight. Also always use a safety cable that
of people and has no one pass by or under
it.
1
3
22
FEMALE
XLR
GROUND
DMX +
DMX -
MALE
XLR
3
1
CAUTION!
DMX signal has to be terminated with a
DMX
Controller DMX 512 DMX 512

The connection is performed using
(included). The device must be
operated by qualified personnel.
5.2 Voltage specification
User Manual •Instrukcja Obsługi
Input Voltage Total Power Frequency
100~240V 120W 50/60Hz
5.3 Connecting power supply
CAUTION! In the case of cable damage do not attempt to repair.
person with appropriate permissions.
Make sure that the power grid supply
parameters are consistent with device
parameters and limitations are not

LED MOVING HEAD BEAM 80W •Art No F7100518
Display Value Noted Description
DmxAddr 001- 512 DMX address select
WorkMod
DMX512 DMX Mode
AUTO Auto Mode
SOUND Sound Mode
MS Master Master Mode
MS Mode Slave Slave Mode
ChanMod 11Ch 11 Channels Mode
13Ch 13 Channels Mode
Control CH01-CH45 Manual control Mode
Tool
Display ON LCD Display ON
60S LCD Display Off after 60s no operate
SundHig 0-32 Sound sensitive
IR SW OFF Remote turn Off
YES Remote turn On
MotorST
Colr REV 0-255
Gobo REV 0-255
Prim REV 0-255
Fous REV 0-255
Pan REV 0-255
Tilt REV 0-255
X reverse NO Pan Forward
YES Pan Reverse
Y reverse NO Tilt Forward
YES Tilt Reverse
X yfbstin NO XY Optical Coupling Closed
YES XY Optical Coupling Open
Info
Version Software Version
RDM UID UID Code
Runtime Units: hours
Rest NO
YES Reset
7. MAIN FUNCTION CHART

8. DMX CHANNELS
User Manual •Instrukcja Obsługi
CH 11 CH 13 Function Value Description
1 1 Pan 0-255 0-5400
2Pan ne 0-255 0-20
2 3 Tilt 0-255 0-2700
4Tilt ne 0-255 0-20
3 5 Position Speed 0-255 Fast - Slow
4 6 Dimmer 0-255 0-100%
5 7 Strobe 0-19 Close
20-49 Open
50-64 Strobe
65-69 Open
70-84 Ramp IN
85-89 Open
90-104 Ramp Out
105-109 Open
110-124 Pulse
125-129 Open
130-144 Random
145-149 Open
150-164 Random Puls
165-169 Open
170-184 Pulse
185-189 Open
190-204 Ramp
205-209 Open
210-224 Sinus
225-229 Open
230-244 Strobe effect
245-255 Open
6 8 Color 0 Open
1-130 Continus Color Wheel
131-133 Red

LED MOVING HEAD BEAM 80W •Art No F7100518
CH 11 CH 13 Function Value Description
137-139 Green
143-145 Blue
149-151 Yellow
155-157 Orange
161-163 Magenta
167-169 Cyan
173-175 Sea Green
179-181 Pink
195-219 Spin << Fast - Slow
220-224 Stop
225-249 Spin >> Slow - Fast
250-255 Macro
7 9 Gobo 0-4 Open
5-9 Gobo 1
10-14 Gobo 2
15-19 Gobo 3
20-24 Gobo 4
25-29 Gobo 5
30-34 Gobo 6
35-39 Gobo 7
40-44 Gobo 8
45-49 Gobo 9
50-54 Gobo 10
55-59 Gobo 11
60-64 Shake Open
65-74 Shake Gobo 1
75-84 Shake Gobo 2
85-94 Shake Gobo 3
95-104 Shake Gobo 4
105-114 Shake Gobo 5
115-124 Shake Gobo 6
125-134 Shake Gobo 7
135-144 Shake Gobo 8

CH 11 CH 13 Function Value Description
145-154 Shake Gobo 9
155-164 Shake Gobo 10
165-174 Shake Gobo 11
175-184 Open
180-204 Spin << Fast - Slow
205-214 Stop
215-239 Spin >> Slow - Fast
240-255 Macro
8 10 Prism Roto 0-15 Open
16-127 Prism
128-255 Roto Slow - Fast
9 11 Focus 0-255 Far - Near
10 12 Macro 0-19 Open
20-99 Auto
100-199 Sound
200-255 Open
11 13 Reset 0-249 Open
250-255 Reset
User Manual •Instrukcja Obsługi

2. ZASADY BEZPIECZENSTWA
1. WPROWADZENIE
3. INFORMACJE O PRODUKCIE
4. INSTALACJA
MOVING HEAD BEAM 80W
przez wykwalifikowany personel, aby
w dobrze wentylowanym pomieszczeniu,
uszkodzenia spowodowane niestabilnym
LED MOVING HEAD BEAM 80W •Art No F7100518

5.2 Specyfikacja zasilania
5.3 Podłączenie zasilania
Napięcie Zasilania Pobór Mocy Częstotliwość zasilania
100~240V 120W 50/60Hz
5.1 Podłączenie sygnału DMX
5. POLACZENIA
1
3
22
FEMALE
XLR
GROUND
DMX +
DMX -
MALE
XLR
3
1
UWAGA!
wykwalifikowany personel techniczny.
User Manual •Instrukcja Obsługi
DMX
Controller DMX 512 DMX 512

Display Value Noted Description
DmxAddr 001- 512 DMX address select
WorkMod
DMX512 DMX Mode
AUTO Auto Mode
SOUND Sound Mode
MS Master Master Mode
MS Mode Slave Slave Mode
ChanMod 11Ch 11 Channels Mode
13Ch 13 Channels Mode
Control CH01-CH45 Manual control Mode
Tool
Display ON LCD Display ON
60S LCD Display Off after 60s no operate
SundHig 0-32 Sound sensitive
IR SW OFF Remote turn Off
YES Remote turn On
MotorST
Colr REV 0-255
Gobo REV 0-255
Prim REV 0-255
Fous REV 0-255
Pan REV 0-255
Tilt REV 0-255
X reverse NO Pan Forward
YES Pan Reverse
Y reverse NO Tilt Forward
YES Tilt Reverse
X yfbstin NO XY Optical Coupling Closed
YES XY Optical Coupling Open
Info
Version Software Version
RDM UID UID Code
Runtime Units: hours
Rest NO
YES Reset
7. TABELA FUNKCJI
LED MOVING HEAD BEAM 80W •Art No F7100518

8. LISTA KANALOW DMX
CH 11 CH 13 Function Value Description
1 1 Pan 0-255 0-5400
2Pan ne 0-255 0-20
2 3 Tilt 0-255 0-2700
4Tilt ne 0-255 0-20
3 5 Position Speed 0-255 Fast - Slow
4 6 Dimmer 0-255 0-100%
5 7 Strobe 0-19 Close
20-49 Open
50-64 Strobe
65-69 Open
70-84 Ramp IN
85-89 Open
90-104 Ramp Out
105-109 Open
110-124 Pulse
125-129 Open
130-144 Random
145-149 Open
150-164 Random Puls
165-169 Open
170-184 Pulse
185-189 Open
190-204 Ramp
205-209 Open
210-224 Sinus
225-229 Open
230-244 Strobe effect
245-255 Open
6 8 Color 0 Open
1-130 Continus Color Wheel
131-133 Red
User Manual •Instrukcja Obsługi

CH 11 CH 13 Function Value Description
137-139 Green
143-145 Blue
149-151 Yellow
155-157 Orange
161-163 Magenta
167-169 Cyan
173-175 Sea Green
179-181 Pink
195-219 Spin << Fast - Slow
220-224 Stop
225-249 Spin >> Slow - Fast
250-255 Macro
7 9 Gobo 0-4 Open
5-9 Gobo 1
10-14 Gobo 2
15-19 Gobo 3
20-24 Gobo 4
25-29 Gobo 5
30-34 Gobo 6
35-39 Gobo 7
40-44 Gobo 8
45-49 Gobo 9
50-54 Gobo 10
55-59 Gobo 11
60-64 Shake Open
65-74 Shake Gobo 1
75-84 Shake Gobo 2
85-94 Shake Gobo 3
95-104 Shake Gobo 4
105-114 Shake Gobo 5
115-124 Shake Gobo 6
125-134 Shake Gobo 7
135-144 Shake Gobo 8
LED MOVING HEAD BEAM 80W •Art No F7100518

CH 11 CH 13 Function Value Description
145-154 Shake Gobo 9
155-164 Shake Gobo 10
165-174 Shake Gobo 11
175-184 Open
180-204 Spin << Fast - Slow
205-214 Stop
215-239 Spin >> Slow - Fast
240-255 Macro
8 10 Prism Roto 0-15 Open
16-127 Prism
128-255 Roto Slow - Fast
9 11 Focus 0-255 Far - Near
10 12 Macro 0-19 Open
20-99 Auto
100-199 Sound
200-255 Open
11 13 Reset 0-249 Open
250-255 Reset
www.flash-butrym.pl
F7100518
Table of contents
Other Flash Light Fixture manuals

Flash
Flash F7100083 User manual

Flash
Flash F7100552 User manual

Flash
Flash F7110001 User manual

Flash
Flash F7200202 User manual

Flash
Flash F7300228 User manual

Flash
Flash moving head led 15w User manual

Flash
Flash 4in1 ZOOM F7000544 User manual

Flash
Flash F7100515 User manual

Flash
Flash F7000499 User manual

Flash
Flash F7100299 User manual