Fleck 5600SXT Owner's manual

www.h2ofilters.ca


FLECK 5600 SXT WATER
SOFTENER PROGRAMMING
TO ENTER INTO MASTER PROGRAMMING: Press the arrow up button and set the time to 12:01
P.M., then press the extra cycle button once. Now press the up and down buttons together for
approximately 8 seconds until the display changes to the programming mode.
The display should now be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.

www.h2ofilters.ca

Next display should be:
You may need to use the arrows to adjust this setting. For a 1.5 cubic foot (45,000 grain) softener set
this to 35.0, for a 1.0 cubic foot (30,000 grain) softener, set it to 27.0.
Press the Extra Cycle button to advance to the next step.
Next display should be the hardness level. Use the arrow buttons to adjust
the number to the amount of grains of hardness in your water. This should
be the amount of hardness in your water + ppm of iron x 4.
Example: If you have 12 grains of hardness and 2 ppm of iron you need to enter 20. 12 + (2x4) = 20
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.

www.h2ofilters.ca

Next display should be:
Press the Extra Cycle button to advance to the next step.
Next display should be:
You may need to use the arrows to adjust this setting. For a 1.5 cubic foot (45,000 grain) softener set
this to 9 and for a 1.0 cubic foot (30,000 grain) softener, set it to 6.
Press the Extra Cycle button to advance to the next step.
Next display should be:
Press the Extra Cycle button to advance to the next step.
Only if necessary: press the Extra Cycle button again until the time of day is shown.
NOW SET THE CURRENT TIME OF DAY: Press and hold the up or down arrow for 5 seconds. The
display will read TD with the time of day. Adjust to present time of day and press the extra cycle
button (button with the circle of arrows).
START-UP
1. Open nearby faucet in COLD position and slowly open bypass valve on softener or turn main water
supply on to allow air to escape from tank.
2. Wait a few minutes then open bypass or main supply open completely, slowly.
3. Allow water to run out of faucet for 5 minutes.
4. Add salt to the brine tank. Always keep the tank at least 1/3 full of salt.
5. Add approximately 3 gallons of water to the brine tank.
6. Press the extra cycle button, the faucet icon will start to flash.
7. Your done.
*** If you ever see the time flashing, press the extra cycle button once and it will stop.
*** The display will rotate between the time of day and the gallons of water remaining before the next
regeneration. This is normal.
*** Always keep the salt level above the water in the brine tank.