Flower House Hanging Pumpkin Chair User manual

(4) Legs
(4) Rubber feet
(1) Lower Bow with X connection
(1) Upper Bow
(1) Main Chair C-Frame
(1) Bottom Flat Cushion
(1) Leisure Cushion
(3) Attachment Straps
(1) Wrench
(2) Allen Wrench
(10) Nuts and Bolts
(4) Wedges
(1) Lever Tool
Parts and Assembly Instructions for
Hanging Pumpkin Chairs
•PO Box 595 Clio, Michigan 48458 •Office: (810)-686-8252 •Fax: [phone] •[e-mail] •
Images are not to scale

Assembly Instructions for Hanging Pumpkin Chairs
2. Connect the four
legs to the X-frame
on the lower bow of
the stand using the 4
shorter nuts and
bolts.
Attach upper bow to
lower bow with the
longest 2 nuts and
bolts.
1. Open the package
and unwrap the four
short legs and put
rubber feet on each of
the four legs (if not
already attached).
3. Open chair frame
completely and put the
four smallest nuts and
bolts in place.
Make sure the flat tops
are on the inside of the
chair, so they do not
poke through the fabric
or through the seat.
4.Take the center loop
and slide through top
cover opening.
Proceed to close top
and bottom pan covers
by connecting hooks to
eyelets.
5. One at a time, slide the
side strap O-rings over
the center attachment
strap.
6. Pull the center strap taut
through the stacked O-rings.
7. Lift the chair and slide
the attachment strap over
the end cap into the
securing tabs.
Place the bottom flat
cushion on the seat of the
chair then place the leisure
cushion on top.
8. Make sure all nuts and
bolts are tightened
throughout the stand and
chair. Place in any level
location and enjoy your
Hanging Chair!
Thank you for your
business!
PATENT:
www.flowerhouses.com/patents
*Specifications subject to change without notice
(optional)
Insert wedges with interlocking
teeth facing each other in between
outermost rib and bolts for optimal
appearance/tightness.
Before starting assembly, unpack entire contents of box and check that all parts are accounted for.
Contact FlowerHouse for any replacement or repair issues:
[phone] –[email protected]
Images are not to scale

How to use lever tool
(used for assembly assistance)
Place the peg of the curved end of
lever on the inside middle of the pan,
with the peg of the straight bar on the
outside.
Pull the straight bar towards the outer
rib of the chair.
This will create the clearing necessary
to insert bolts and wedges into posi-
tion.
Place bolts, fasten with nuts, and
follow by inserting wedges in
between outermost rib and bolt.
Flip lever tool to repeat on other side,
top and bottom.
- PO Box 595 Clio, MI 48420 - Oce: [phone] - Fax: [phone] - www.owerhouses.com -
Images are not to scale
Before starting assembly, unpack entire contents of box and check that all parts are accounted for.
Contact FlowerHouse for any replacement or repair issues:
[phone] - customerservice@owerhouses.com