flyp pe1200m Installation guide

Care Instructions
Daily Cleaning
On the Go Deep Cleaning
Optional Disinfection

STOPPER
CARTRIDGE
(MEDICATION
RESERVOIR)
MEDICATION
RESERVOIR
MOUTHPIECE
POWER
BUTTON
For full care instructions, see the Flyp Owner's
Manual or Quick Start Guide.
Daily Cleaning Instructions:
Rinse reservoir. Clean mouth-
piece with mild soap & water.
REMOVE AND CLEAN
STEP 2
STEP 7
3.
Press and hold power button
for 5 seconds. Run for 1-2
minutes or until empty.
RUN FOR 1-2 MINUTES.
STEP 4
STEP 7
3.
Reinsert the Reservoir and
fill with water
STEP 3
FILL WITH
WATER
H2O
Check the Medication Reservoir
to make sure it is empty.
STEP 1
OPEN THE
RESERVOIR
STOPPER

1. Break o one ampule of “A”
Cleaning Solution and one
ampule of “B” Distilled Water
from your package. Set both
aside.
2. Open the stopper on the
HypersonIQ® cartridge
(medication reservoir).
3. Twist o the top of one “A”
Cleaning Solution ampule.
4. Insert the “A” Cleaning
Solution ampule into
reservoir and squeeze to
empty contents.
5. Close the reservoir, hold Flyp
vertically, and gently raise
the Mouthpiece with your
index finger.
6. Press and hold the power
button for 5 seconds. Blue
AND yellow indicator lights
will start to blink and Flyp
will produce a pulsing
aerosol.
7. Allow the aerosol mist to flow
from the raised Mouthpiece
until cleaning solution is
completely gone.
8. Power Flyp o by pressing
the power button.
9. Remove HypersonIQ
cartridge and shake out any
excess cleaning solution.
10. Replace the HypersonIQ
cartridge.
11. Open the stopper on the
HypersonIQ cartridge
(medication reservoir).
12. Twist o the top of the “B”
Distilled Water ampule.
13. Insert the “B” Distilled
Water ampule into reservoir
and squeeze to empty
contents.
14. Repeat steps 5 - 9.
15. Let the main unit, cartridge,
and
mouthpiece dry on a clean,
dry towel.
16. Allow the interior to dry
fully prior to using again.
PART
B
PART
A
CLEANING
SOLUTION
A
DISTILLED
WATER
B
Note: Ampules may appear dierent than above
Deep Cleaning Instructions:

Optional Disinfection Instructions:
IMPORTANT USE ONLY AS DIRECTED. The purpose of these cleaning instructions is to ensure a cleaner and
more eicient operation of your nebulizer. It is important to use the cleaning solution (Vial #1) FOLLOWED by
the distilled water provided (Vial # 2) in this package before using your nebulizer. Before you use the
On-the-Go Cleaning vials or your nebulizer, consult with your healthcare provider about all of your current
medical conditions and allergies. Be sure to tell your doctor if you are pregnant, think you might be pregnant,
or plan to become pregnant. Tell your healthcare provider if you are breast-feeding. Tell your healthcare
provider about all other medications you are currently using. Tell your caregiver right away or call 911 if you
have chest pain, trouble breathing, swelling in your hands or feet, tiredness, confusion, uneven heart rate,
extreme thirst, increased or decreased urination, leg discomfort, muscle weakness or limp feeling, or if you
feel like you might pass out. ALLERGY WARNING: THIS PRODUCT CONTAINS 5% ACETIC ACID (VINEGAR).
HYPERSONIQ CARTRIDGE AND MOUTHPIECE
STEP 1
Remove the HypersonIQ Cartridge and
mouthpiece from Flyp.
STEP 2
Soak the mouthpiece and cartridge in
70% ethyl alcohol for 10 minutes. Make
sure both are completely submerged in
the alcohol.
STEP 3
Remove mouthpiece and cartridge
from the alcohol bath and rinse under
running water.
STEP 4
Let dry on a clean, dry towel.
EXTERIOR
STEP 1
Wipe exterior with clean, dry towel
moistened with ethyl alcohol.
STEP 2
Allow Flyp to sit for 5 minutes.
STEP 3
Moisten with a clean dry towel with
water and wipe exterior to remove the
ethyl alcohol.
STEP 4
Let dry on a clean, dry towel.