foc.us Sentech SDS tag User manual

Turn tags on/o
Option 1: by SDS Base Station
Just tap the SDS Base Station with the SDS tag to turn on the tag. The LED
fades in to indicate that the device is turned on. Then the LED blinks every
15 seconds to indicate that the device is turned on and active. Your SDS tag
is ready for use now. To turn o the tag, just tap the SDS Base Station again.
The LED will fade out to indicate that the device is turned o.
Option 2: by charging cable
Disconnect the charging cable to turn on the tag. Once the charging cable is
connected, the tag turns o.
Pairing multiple tags
1. Connect up to 10 SDS Base Stations to each other, to pair an equivalent
number of tags.
2. Make sure the tags are turned o. Then place the tags you want to pair in
the SDS Base Stations. The tags will start pairing automatically, indicated
by the blinking LEDs.
3. The tags are paired when their LEDs stop blinking and remain static. Now
the tags are ready for use.
Quick Start Guide
SDS tag

Turn on tags
Place the SDS tag in the SDS Base Station. The LED lights up in the colour
of the battery status (red, orange, green) for 2 seconds. Now, remove it from
the SDS Base Station. It is ready for use. A green blink indicates that the
device is turned on and active. Disconnecting the charging cable from the
tag will also turn on the tag.
Turn o tags
Place the tag in the SDS Base Station to turn the tag o. A white light will
fade out. Plugging the charging cable into the tag will also turn o the tag.
Pairing Multiple tags
1. Connect two or more SDS Base Stations to each other.
2. Place the tags you want to pair in the SDS Base Stations, make sure the
tags are turned o and are placed in the stations within 30 seconds from
each other. The tags will start pairing automatically, indicated by the tags’
LEDs blinking blue.
3. The tags are paired when their LEDs stop blinking and remain blue. They
can now be removed from the SDS Base Stations.
Notification when violating 1.5 meters
A tag gives a notification when it is within 1.5 meters of another tag (unless
it is paired to this tag). The user is notified by an LED light- and vibration
of the tag. When the violation takes place for longer than 2 seconds, an
additional sound- signal is emitted. The notification stops as
soon as the distance between respective tags is bigger than 1.5
meters again.
Contact the supplier
Sentech B.V.
Looier 5
5253 RA Nieuwkuijk
The Netherlands
[e-mail]
Phone: [phone]
www.socialdistancingsensor.nl
Manufacturer
Focus Technologies B.V.
Flight Forum 3360
5657 EW Eindhoven
The Netherlands
Phone: [phone]
www.findfocus.nl
Notification when violating 1.5 meters
A tag gives a notification when it is within 1.5 meters of another tag (unless
it is paired to this tag). The user is notified by an LED light- and vibration
of the tag. When the violation takes place for longer than 2 seconds, an
additional sound-signal is emitted. The notification stops as soon as the
distance between respective tags is bigger than 1.5 meters again.
LED indications
Fade in: Tag turns on Blinking 1x/15 sec: Tag is on
Fade out: Tag turns o Blinking 2x/3 sec: Battery low
Blinking: Pairing mode Static: Battery is full
Static: Pairing succeeded Breathing: Charging mode
When tag is on SDS Base Station: When tag is connected with charger: