Force1 F200C SPECTER User manual

FIRST LOOK
FLIGHT GUIDE
Any questions? We’d love to hear from you! Please include your order number when
you contact us at [e-mail] for fast, friendly service.

NOTE:
Follow the Preflight Operation steps in the user manual if your drone
doesn’t start or isn’t performing properly.
5The drone is ready to y. See the Preight
Checklist and Basic Flight Controls sections
in the user manual before operating for
more detailed instructions.
QUICK START GUIDE
1
2
3
4
FIGURE 1
FIGURE 4
Press and hold the top-left red button while
powering on the transmitter (Fig. 1). Once
the indicator light starts flashing, insert the
drone battery. The transmitter will emit a
single beep when the drone and transmitter
are paired.
Place the drone on a flat surface, facing
away from you. Move the left and right
sticks down and inward simultaneously (Fig.
4). Drone propellers will rotate, indicating it
is unlocked.
When the drone’s front and rear
lights ash yellow, rotate the
drone horizontally 3 times (parallel
to the ground) or until the lights
start ashing green (Fig. 2).
Now, point the drone nose down and rotate
the drone 3 times (perpendicular to the
ground) until you see solid red and yellow
lights. (Fig. 3).
FIGURE 2
FIGURE 3

Why are the yellow lights flashing quickly?
Why are the green lights flashing quickly?
Why are the yellow lights flashing in alternate patterns?
What do solid red and yellow lights mean?
What do solid red and slow flashing red lights mean?
What do solid red and fast flashing red lights mean?
Why did the lights flash once and then go off?
Why did the lights flash twice and then go off?
Why did the lights flash three times and then go off?
Why did the lights flash four times and then go off?
What do solid red and green lights mean?
Why are the green lights flashing in alternate patterns?
Why are the green and yellow lights flashing in alternate patterns?
The drone is not paired. Follow pairing instructions.
The drone is calibrating its gyroscope.
The drone is calibrating its horizontal compass.
There is no GPS signal. Move to a new location. Turn drone and transmitter off and restart
the pairing/calibration process.
Battery is at 1/4 power.
Battery is at 1/6 power.
There’s a gyroscope issue. Turn drone and transmitter off and restart the pairing/
calibration process.
There’s a gyroscope issue. Turn drone and transmitter off and restart the pairing/
calibration process.
There’s a gyroscope issue. Turn drone and transmitter off and restart the pairing/
calibration process.
There’s a gyroscope issue. Turn drone and transmitter off and restart the pairing/
calibration process.
Good GPS signal.
The drone is calibrating its horizontal compass.
The drone is initializing signal detection.
TROUBLESHOOTING GUIDE
For FCC Information, please see the user manual.

WARNING:
DO NOT LEAVE
BATTERY CHARGING
UNSUPERVISED.
Follow the steps below to charge your battery (failure to follow instructions precisely may result in
damage to your battery charger):
1. Connect the charging cord to the charger.
2. Plug in the charger.
3. Carefully connect the battery cable to the charger as shown below.
4. Charger indicator light will turn green when charging is complete.
WARNING:
DO NOT plug the battery cable into the battery charger upside down. This will
render the charger inoperable.
DRONE BATTERY CHARGING