Forest 2.4M ULTIMA PERGOLA Manual

FIXING PACK CONTAINS:
It’s vital that you build your new pergola on a level ground in your desired location.
5 x 60mm Screws
QTY: 24
Making British gardens great
2.4M ULTIMA PERGOLA
KIT INSTRUCTIONS
ISSUE: 0221
FIXING PACK CODE: UPERG24FP
We recommend using the following tools (NOT SUPPLIED):
Tape
Measure
Pozidrive
Screwdriver
Drill & 2mm
Drill Bit
Hammer Ladder Spirit Level
REMINDER
Always pre-drill before
screwing.
IMPORTANT
Assembly requires 2+
adults.
PLEASE KEEP PLASTIC BAGS AND SMALL PARTS AWAY FROM CHILDREN
THE ROOF OF THIS PERGOLA IS NOT A LOAD BEARING STRUCTURE
3.5 x 25mm Screws
QTY: 48
U-Brackets
QTY: 12
Forest Garden, Oak Drive, Hartlebury Trading Estate, Hartlebury, Worcestershire, DY10 4JB
Missing something or need more information?
Call our aftersales team on
0333 777 7089
Visit our website for spare instructions and
more information
www.forestgarden.co.uk

303mm 301.5mm 301.5mm 301.5mm 301.5mm 301.5mm 303mm
1
2
Fix 6 x U-Brackets on two of the rafters. Spread out evenly using the measurements provided and secure into
place. You will only have 2 rafters with the U-Brackets.
CONSTRUCTION
130mm
750mm
PREPARATION
We strongly advise that you anchor your pergola down with either xtures shown below to enhance stability. You
will need to purchase these separately. Apply each xture to each leg before fully constructing your pergola.
130mm of your post will be supported within the xture.
FOR PATIO/DECKING (HARD SURFACES)
Easy-Fit Fencebase - 65mm
(FBEF65)
FOR GRASS/SOIL
(SOFT SURFACES)
Easy-Fit Fencefast
(FEF6575)
Ensure that the spike can be
inserted into the ground by
750mm.
25MM
SCREWS
25MM
SCREWS
Place the other rafters into the U-Brackets. Ensure each rafter is evenly positioned at each overhanging end. Then
secure together at each side.
303.75mm
303.75mm

280mm
1650mm
1650mm
3
60MM
SCREWS
4
60MM
SCREWS
Part Code
Description No.
USU24BI Slotted Post 95 x 95 x 2400mm 4
URCB8BI Rafters 95 x 47.5 x 2400mm 8
UCBCBI
Curved Corner Braces 8
Ultima Pergola Kit 2.4M (UPERG24)
CHECK YOU HAVE ALL YOUR PARTS.
(The parts do not have codes on them. They are listed below should you need to order one.)
TREATED TIMBER CONTAINING A BIOCIDAL PRODUCT
CONTROL OF WOOD DESTROYING ORGANISMS
Active Ingredients - Propiconazole, Tebuconazole, IPBC, Permethrine, Benzyl-C12-16-Alkyldimethyl Chlorides. (Dip Treated)
Basic Copper Carbonate, DDA Carbonate, DDA Chloride. (Pressure Treated)
Wear gloves when handling. Avoid inhalation of sawdust. Do not use in contact with drinking water or food. Do not use for animal
bedding or in sh ponds. Dispose of treated wood responsibly.
The components provided may be heavy. Please lift with caution and with a minimum of 2 people.
Place the assembled roof onto the notched posts. Ensure post is distanced 1650mm from each other if using
xtures. Carefully knock the rafters into the notches. Fix together using 2 x 60mm screws per post.
Secure each angle brace with 2 x 60mm screws. Use the visuals above as guidance.