Foster LC125 User manual

LC125
MEATWELL
FREEZER
Foster Refrigerator
Oldmedow Road
Kings Lynn
Norfolk
PE30 4JU
Tel: [phone]
Fax: [phone]
Website: www.fosterrefrigerator.co.uk
Email: [email protected]
a Division of ‘ITW (UK) Ltd’
LC125 /SM/07/04

1
DISPOSAL REQUIREMENTS
If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in accordance
with UK laws and regulations.
Contents Page
Introduction 1
Technical Information 1
Temperature Controller 1
Controller Parameters 2
Alarms and Warnings 2
Electrical Connections 2
Wiring Diagram 3
Introduction
Top loading meatwell for the storage of frozen
products
One piece foam shell with skin evaporator and
bottom
mount condensing system.
R 134A refrigerant
Fitted with corner bumpers to each side.
Front smash bar as an option, fitted as standard for
Burger King.
Fitted with 4 x 60mm castors.
Technical Information
Temperature Set Point -21°C
Refrigerant R134A
Refrigerant Charge 180 gms
Capillary 4.5mts x 042
Power supply 230/50/1
Temperature Controller
When the controller is switched on a single line appears on the display for 3 seconds to indicate the autotest
period.
After this period the air temperature measured by the T1 probe is displayed.
It is strongly advised that before adjusting any Service Parameters a thorough understanding of the
following instructions should be obtained.
LDU 15 Controller
Check temperature set point.
Check set point by pressing the button
To increase set point press +
To decrease set point press +
Factory Temperature Set Point -21°C.
Exit from set up occurs after 10 seconds if no button is pressed.
Controller Set Up.
The parameters are accessed by pressing the following keys in succession + +
and keeping them pressed for 3 seconds.
Access to the parameters has been achieved with the first parameter SCL being displayed.
To pass from one parameter to the next press either the or key.
To display the value press.
To change the value press + to increase, or + to decrease.
aux
lae
set
au
x
set
set
set
set
set
set
set

1
Controller Parameters
Display Parameter LDU151E-B
Default Values LC 125
SCL Readout Scale 2°C 2°C
SPL Minimum Temperature Set Point 05 -25
SPH Maximum Temperature Set Point 01 -15
SP Effective Temperature Set Point 03 -21
HYS Hysteresis 3+3
CRT Compressor Rest Time (minutes) 10 0
CDC Compressor Regulation with T1 Fail 20 7
DFR Defrosting Frequency (/24 hours) 4 0
DTO Defrosting Duration (minutes) 20 20
DDY Defrost Display Control 1 1
ATL Low Alarm Differential -5 -10
ATH High Alarm Differential 510
ATD Temperature Alarm Delay (minutes) 60 90
ACC Condenser Clean Interval 05 0
OAU Auxiliary Output Mode of Operation 30 NON
BAU Auxiliary Button Mode of Operation 05 NON
OS1 T1 Offset 00 00
SIM Display Slowdown 00 00
ADR Address 01 01
Alarms and Warnings
HI High Temperature Alarm
LO Low Temperature Alarm
E1 T1 Probe Failure
DF Defrosting in Progress
CLN Condenser
LDU 151E-BG Electrical Connections
PARTS LIST
ITEM Description Part Number
Temperature Controller LDU 151E-BG 00-555357
Air Probe T1 POA
Rocker Switch 15243562
Rocker Switch Cover 15243609
Capillary 4.5 mts X 042" 16010654 (sold in 5m lengths)
Compressor GL60AA 15427002
Drier 1/4 DBL ENT1/4 OUT R134 15480908
Condenser 15432001
Condenser Fan Motor Grid Mount 5W 15470032
Corner Bumpers 15260653
Front Smash Bar 00-744880-01
Castor 60mm Swivel 00-555335
Castor 60mm Swivel Braked 00-555336
PWR
1 2 3 4 5 6 7 8 9 10 11
AUX
T1
DATA

Wiring Diagram