Fotric 226B User manual

1. Installation
The product has the American Standard 1 / 4-20unc tripod interface (the upper part
and the lower part have interfaces), which is convenient for customers to install;
There are four cushions at the four corners of the bottom, which can be used for
horizontal placement of products.
Tripod installation eect drawing

2. Quick Setup
1. Connect the blackbody to the AC220V power supply and turn on the power switch.
2. The power indicator is on, and the display shows the default temperature of 35.0℃,
Set the blackbody temperature to 40℃by adjusting the up and down buttons. After
5 minutes of preheating, the machine is stable and can be used normally.

3. Display panel
4. Matters needing attention
1. Please ensure the correct power input
2. Please do not touch the black target area to prevent scalding
3. It is better to use the product at room temperature of about 25℃to ensure the
accuracy of the equipment
4. Avoid using in humid and over temperature environment, otherwise it will aect the
accuracy of the equipment

5. Product parameters
Packing list:
Blackbody, power cord (one), product manual
After-sales service:
The warranty period of this product is 1 year.
Working Voltage
Max Power Dissipation
Working environment Temperature
Settable Temperature
Calibration Temperature
Emissivity
Temperature Resolution
Settling Time
Temperature Accuracy
Temperature Stability
Eective radiation surface
Dimensions (LxHxW)
AC100V~240V
260W
0℃~+40℃
RT+5℃~100℃
35℃~40℃
0.97±0.02
0.1℃
≤5min
±0.2℃@36℃
±（0.1℃~0.3℃）/h
100mm*80mm
L195*W150*H110
Blackbody

FOTRIC INC.
www.fotric.com
[email protected]