Fotric 340 Series Instruction manual

FOTRIC 340 Series

Laser distance Ranger
and laser pointer
Specifications
Download
General
Laser warning label
Laser rules and regulations
13
12
Main Accessories
11
Statement
26
Contact
28
19
21
22
23
24

is committed to

Represents a hazardous situation or behavior that could
result in personal injury or death.
Represents conditions or actions that could result in
damage to the instrument or permanent loss of data.
Represents useful information for users.

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Notice To avoid potential hazards, Please do not use any batteries,
chargers and charging docks which are not specified by the manufacturer.

Laser Label

Power Supply

The documentation shall indicate that only accessories which meet the
manufacturer’s specifications shall be used.
Power adaptor
Model No.: ABT030120A
input：100-240V ~ 50/60Hz 1.5A
output: 12V dc 3.0A
Battery charging dock
Part No.: F900001ACC
12V dc 3.0A
Batteries
Lithium-ion rechargeable batteries (7.4V, 3500mAh) 18Wh
Model No.: F900002ACC
Operation temp: -20~50 ℃
USB cables
USB type-C type; conforms to USB 3.0 / 2.0 specification, supports USB OTG;
USB 3.0 has a maximum speed of 5Gbps; USB 2.0 supports a maximum speed
of 480Mbps, and is downward compatible with full speed (12Mbps) mode
HDMI cables
Micro HDMI type,Comply with HDMI 1.4 specification, support 1080p image
video transmission at 60Hz frame rate
Anti-interference magnetic ring
User Guide: The two snap on type magnetic rings shall be buckled mounted at
both ends of HDMI cable respectively, and the position shall be close to the
cable inlet and outlet as close as possible, which distance shall not be more
than 50mm.
Main Accessories
11

Laser distance Ranger and
laser pointer
1. General
The laser distance ranger consists of a laser transmitter and a laser receiver. The
laser distance ranger determines the distance to a target by measuring the time
it takes for a laser pulse to reach the target and return to the laser receiver. This
time is converted to a distance, which is displayed on the screen.
The laser receiver also works as a laser pointer. When the laser distance ranger
is on, youwill see a laser dot approximately at the target.
2. Laser warning label
A laser warning label with the following information is attached to the camera:
3. Laser rules and regulations
Wavelength: 635 nm. Maximum output power: 1 mW.
This is Class 2 Laser Product.
Complies with 21 CFR 1040.10 and 1040.11 except for conformance with IEC
60825-1 Ed. 3., as described in Laser Notice No. 56, dated May 8, 2019.
Caution: Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
12

Wi-Fi
GPS,
13

image fusion
14

15

Capture mode, connection, temperature measurement range,
storage and save options, device set.
16

17