Fox Electronics GR2015-R User manual

PTC
FOX GR2015-R
AC220-240V 50-60Hz 2000W
Sigurnosno uputstvo

220-

samo

(ZA PTC-2280Y)
1)
”
)
2) ”

”
”
" - – "
3) " "
15
4) " "
5) " "
"22 -25 -28 "
:
)

:

FOX GR2015-R
USER MANUAL
PTC HEATER
AC220-240V 50-60Hz 2000W
PLEASE SAVE THESE INSTRUCTIONS
WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.

Safety instrucon
Read ALL instrucons before using this unit.
1. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself.
2. This heater may get hot when in use. To avoid burns, DO NOT let bare skin touch hot
surfaces. If provided, use handles when moving this heater.
3. Keep combuse materials, such as furniture, pillows, bedding, paper, clothes, and
curtains at least 3 from the front of the heater and keepthem away from the sides,
top, and rear. DO NOT place towels or other objects on the heater.
4. Extreme cauon is necessary when any heater is used by or near children or the
disabled, or when the heater is leoperag and unaended.
5. DO NOT operate any heater with a damaged cord or aer the heater malfuncons, has
been dropped or damaged in any manner. Return heater to authorized service facility
for examinaon, electrical or mechanical adjustment, or repair.
6. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locaons. NEVER locate heater where it may fall into a bathtub or other water container.
To protect against electrical hazards, DO NOT immerse in water or other liquids.
7. DO NOT touch the control panel or plug with a wet hand.
8. DO NOT run cord under carpeg. DO NOT cover cord with throw rugs, runners, or
similar coverings. Arrange cord away from tra area and where it will not be tripped
over.
9. DO NOT insert or allow foreign objects to enter any venaon or exhaust opening as
this may cause an electric shock or re, or damage the heater.
10. To prevent a possible re, DO NOT block the air intakes or exhaust in any manner. DO
NOT use on sosurfaces, like a bed, where openings may become blocked.
11. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where
gasoline, paint, explosive and/or ammable liquids are used or stored. Keep unit away
from heated surfaces and open ames.
12. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension
cord or relocatable power tap (outlet/power strip).
13. To avoid re or shock hazard, plug the unit directly into a 220-240 V AC electrical outlet.
14. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull rmly on
the plug, DO NOT unplug by pulling on the cord.
15. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
16. Use only for intended household use as described in this manual. Any other use not
recommended by the manufacturer may cause re, electric shock, or injury to persons.
The use of aachments not recommended or sold by unauthorized dealers may cause
hazards.
17. Always use on a dry, level surface. Use on oor only.

18. DO NOT use outdoors.
19. WARNING: To reduce the risk of re or electric shock, DO NOT use this unit with any
solid-state speed control device.
20. DO NOT aempt to repair or adjust any electrical or mechanical funcons on this unit.
Doing so will void your warranty. The inside of the unit contains no user serviceable
parts. Qualied personnel should perform all servicing only.
21. Do not use this heater with a programmer , mer or any other device that switches the
heater on automacally.
22. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualied person in order to avoid a hazard.
23. Heater is not located immediately below a socket-outlet.
24. Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
25. Do not throw the appliance in dustbin with wheels. Do not dispose of electrical
appliances as unsorted municipal waste, use separate collecon facilies. Contact your
local government for informaon regarding the collecon systems available. If electrical
appliances are disposed of in lands or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being. When
replacing old appliances with new ones, the retailer is legally obligated to take back your
old appliance for disposals at least free of charge.
26. In order to avoid overheang, do not cover the heater.
27. This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilies or lack of experience and knowledge if
they have been given supervision or instrucon concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be made by children without
supervision.
28. Children of less than 3 years should be kept away unless conously supervised.
29. Children aged from 3 years and less than 8 years shall only switch on/othe appliance
provided that it has been placed or installed in its intended normal operag posion
and they have been given supervision or instrucon concerning use of the appliance in
a safe way and understand the hazards involved. Children aged from 3 years and less
than 8 years shall not plug in, regulate and clean the appliance or perform user
maintenance.
30. CAUTION: Some parts of this product can become very hot and cause burns. Parr
aenon has to be given where children and vulnerable people are present.
31. WARNING: This heater is not equipped with a device to control the room temperature.
Do not use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
32. Save these instrucons.

PRODUCT STRUCTURE(FOR PTC-2280Y)
Display panel
OPERATION INSTRUCTION
1) Plug the power cord into the power socket, the machine enters the standby state, press the
“ ” buon, the whole machine starts to work, there is hot air(low heag mode) to send out,
and the corresponding indicator light is on, , press “ ” buon again. The whole machine stops
working, and the indicator light is o. (The fan will be delayed to close for 30 seconds, and the
machine enters standby state)
2) When the whole machine is working, press the “ ” buon, the machine works at the
low-level power, while the low-level indicator light is on, and press “ ” buon again, the
machine works at the high-level power, and the high-level indicator light is on, press the “ ”
Control Panel
Remote control

buon conously. The machine works at the "low heat - high heat - cold wind" cycle, and the
corresponding indicator light is on or o.
3) When the machine is in working state, press the " " buon, the machine is in the ming
seg, each me it is pressed, it will increase by 1 hour, up to 15 hours, and the corresponding
indicator will light up. The operaon ends, and the machine will stop working when the ming
seg me is reached.
4) In the power on state, press the " " buon one or more mes, the oscillaon funcon is
turned on or o, and the corresponding indicator light is on or o.
5) When the whole machine is working,press the " " buon, and the machine will cycle in
sequence according to the temperature of "22 -25 -28 ", while the corresponding
indicator light will light up. When the room temperature reaches the preset temperature, the
machine will automacally shut down, and the fan will shut down aer a delay of 30 seconds,
and the machine will enter standby mode. When the room temperature is lower than the preset
temperature, the machine automacally starts and enters the working state.
HOW TO USE THE REMOTE CONTROL:
The remote control use one bun cells, model No.CR2025 ( 3V ) . We recommend the use of
Lithium type baery for longer use.
Note : Please follow baery disposal instrucon on baery packaging , or contact
your local councils for safely disposal of baeries.
INSTALLATION
Base installaon instrucons: (Please conrm whether the accessories are complete and the
product is in good condion before use)
1. Take the base(1 set) and screws(3pcs) pack out of the packing case.
2. Take out the whole machine, align the limit column at the boom of the whole machine with
the limit hole of the chassis, install it in place, and y lock the screws clockwise. (as shown in
the picture below)

Note: When moung the chassis, please stand the machine upside down on the packaging foam
or other sosurface to avoid scratching the product surface.
STORAGE AND MAINTENANCE
1. Turn othe power and unplug the power before cleaning.
2. Aer the product is completely cooled, wipe the outer surface with a socloth, and use a so
brush to clean the venaon holes.
3. Aer cleaning, un the product is completely dried, it can be used by electricity or put into the
original packaging, and placed in a dry and venated place for proper storage.
4. Do not rinse directly with water during the cleaning process to avoid damage to the machine.
5. Avoid using a thinner, toluene, acidic detergent, alcohol and other chemical agents to wipe the
product.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the
return and collecon systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.