4) After moving the unit, place the unit for 30 minutes before switching it on. Running: close the door and connect the power, turn on the lamp switch on the control panel, the lamp is on. Half an hour later, the temperature inside the case lower apparently, it indicates the unit on be normally used5) After connecting the power, the unit should be kept empty for one hour.6. Setting and adjustment of temperature1) Adjust the storage temperature through the temperature controller located on the back of the case(see the picture), adjust the temperature according to the ambient temperature and the foodstuff.2) See the following picture about the knob scale. The temperature adjustable capacity is from “1”-“5”, adjust the storage temperature by turning the temperature controller clockwise. The higher of the number shows the lower of the storage temperature. The knob can turn freely but can't turn clockwise from “5”to “1”. Factory setting position is on “3”.Lamp SwitchThermostat knobControl Panelon off3) Check if the scale is on an appropriate position before using,frequent adjustment is not appropriate when using. Normally in summer, the ambient temperature is high, anti clockwise turn the knob to “2”, while in winter, the ambient temperature is low, clockwise turn the knob to “4”.4) Position “0” represent stop running.7. Storage of articles1) Do not put large amount of articles into the unit at one time, you should leave some space around the foodstuff to let cold air inside the cabinet counter to flow. Keep bottled articles away from the walls of interior cabinet so as not to freeze it until broken.2) Do not put warm food into the unit directly until they are cooled under normal temperature, it will facilitate to lower its energy consumption and prolong service life of the compressor.8. Maintenance Disconnect the power supply before maintenance for the machine!1) Keep the door gasket clean, remove it from the door and wash it. Dry and seal it as before. Putting some talcum powder on the magnetic surface would prolong its service life.2) Bulb replacement： remove the lamp shade, take out the bulb, replace with a new bulb, then mount it again.3) If there is heavy frost on the evaporator after long usage, take out the stuff inside the case, disconnect the power, the frost will melt automatically, clean up the water and connect the power again. 4) Use a soft cloth and dip some water or soap (Non-caustic, neutral detergent is also available) to clean the unit. Dry the unit after cleaning to avoid rust.5) Do not use organic liquid, boiled water, washing powder or acid stuff to clean the unit. Rinsing the case by water is not allowed, don't use hard brush, steel brush to clean the case.6) If the unit will not be used for a long time, disconnect the power, clean it by following the above steps, wipe off the water inside the case with a soft cloth. 9、 Caution1) The unit is not suitable for storage of blood, pharmaceutical products and biological products2) Do not place heavy articles on the top of the unit. 3) In case of trouble, please ask professional person for service, do not dismantle the unit without prior authority to avoid hazard. 10、Normal Phenomena1) Sometime hear light sound of water flowing in the unit, this is the sound of refrigerant flowing inside the pipe.2) the top ,and the two sides of the casing will be warm, even too hot.3) In a humidity place, there is dew on the casing or the door, it can dry by dry cloth.11、Troubleshooting guide
ProblemsPossible causeWays to solve problemsThe units does notworkBad connection ofplugre-connect the plug topower supply
