FreiStil Tischlerei GULLIVER User manual

FreiStil Tischlerei
Böhm und Kinstler GmbH & Co. KG
Ruppenkampstraße 16
D-49084 Osnabrück
Fon ++49 - 541-800 3969 0
Fax ++49 - 541-800 3969 99
E-mail [email protected]
Homepage: www.freistil.com
Operating Manual
Travel Bed
“GULLIVER”
Read carefully before assembling!
OM 2015 Gulliver - D

1. ASSEMBLY INSTRUCTIONS
1.1 Join the long lateral pieces together as shown in the diagrams
(Fig. 1 and Fig. 2) and screw them together with the screws (8 x 30mm) provided.
F Fi ig g. . 1 1
F Fi ig g. . 2 2
Tighten up all the screws and, after you have used the travel bed for some time, check to
make sure they are still tight!
OM 2015 Gulliver - 01

1.2 Join up the bottom, short lateral pieces with the upright posts as shown
in the diagrams (Fig. 3 and Fig. 4) and screw them together with the
screws (8 x 60mm) provided.
Fig. 3
Fig. 4
OM 2015 Gulliver - 02

1.3 Connect the bottom, long lateral pieces (see 1.1) with the pre-
assembled side pieces (see 1.2) as shown in the diagram (Fig. 5).
Mount the rails designed to prevent the bed from falling over as shown
in the diagrams (Fig. 5 and Fig. 6).
If the travel bed is to stand with its long side against a wall, then the
rails must be adjusted (offset) accordingly as shown (Fig. 7).
Fig. 5
Fig. 6
Fig. 7
OM 2015 Gulliver - 03

1.4 Insert the top, long lateral pieces into the sleeves of the net as shown (Fig. 8)
and connect the lateral pieces with the pre-assembled side pieces (see 1.2)
as shown in the diagram (Fig. 9).
Fig. 8
Fig. 9
OM 2015 Gulliver - 04

1.5 Insert the top, short lateral pieces into the sleeves of the net as shown (Fig. 10)
and connect the lateral pieces with the pre-assembled side pieces (see 1.2)
as shown in the diagram (Fig. 10).
Fig. 10
1.6 Fasten the net to the bottom, long lateral pieces via the Velcro
tapes attached to the net.
Fig. 11
Manufacturer: FreiStil Tischlerei, Ruppenkampstraße 16, D - 49084 Osnabrück
Fon ++49 541-800 3969 0, Fax ++49 541-800 3969 99
email: [email protected]
OM 2015 Gulliver - 05