Fresh-Aire UV PURITY LOW PROFILE Installation and operating instructions

Installation
1. Turn o power to the air handler
2. Remove the existing lter from the 2” slot
3. Add foam padding strips (included) to frame as needed to assure a tight t
4. Insert PLP into 2”slot
5. Power the Purity Low Prole (PLP)
A. Use a 110/24 VAC, 40 VA, Class 2 plug-in adapter power supply.
(Part # TUVP-40VA24VAC-WP sold separately)
or
B. Locate the 24 volt AC power source in your HVAC system then connect
the leads of the power cord illustrated in the electrical wiring diagram.
See diagram (Fig. 1)
WARNING: Electrical work should be done by a
qualied electrician or HVAC technician
INSTALLATION
& MAINTENANCE
INSTRUCTIONS2”
IMPORTANT!
• Only qualified technicians should install this product
• Install in accordance with relevant building codes
• Read instructions carefully including safety warnings
Fig. 2 Power Cord
Fig. 1 HVAC Wiring
TANDEM INSTALLATION
1. Mechanically hook-up lter panels at the bottom (See detail “A”)
2. Snap top latches (See detail “B”)
3. Electrically connect the lter panel (See detail “C”)
POWER CONNECTION
By a licence electrical contractor (See “Control Box” instruction)
POWER CONSUMPTION
• 2 VA for each lter, one 24 Volts transformer can be used to power all lters
• Use only 24 VAC to power lters

Collector Pad Replacement
1. Turn o the power on the HVAC system.
2. Open the air handler lter access door.
3. Unplug the 24 volt power-cord and remove the PLP from the lter slot
4. Clean heavy accumulated dust on the outside screen with a vacuum.
5. Open the PLP and remove the old Collector Pad and discard it.
6. Insert new Collector Pad by sliding the electrode into the color tube inside the Pad.
7. Close the Air Cleaner and plug the 24 volt power cord into the power head.
8. Restore HVAC system power.
Note: You may hear a little snapping noise at the beginning. This is normal because of variations in
temperature and humidity. This noise should cease after a few hours of operation. If the noise persists,
contact your HVAC service company.
Periodical Operation Maintenance
Your collector pad should last 4 to 6 months, depending on the amount of air pollutants and fan usage.
For maximum eectiveness of the PLP, we recommend that the fan control on the thermostat be in the
“ON” position.
WARNING: Failure to change the collector pad on a regular basis will result in a reduction of air
ow through the HVAC system. This can cause short cycling of your air handler system and may
cause damage to your equipment.
TUV-PLP2-MAN 032520
www.FRESHAIREUV.com