Typical Installaon Layout
The installaon of an AquaChoice lter is straight forward and
simple. You need a cold water source like under a sink. The
installaon parts are available in the under sink install kit.
Number Descripon Qty
1Valved Angle Stop Adapter 1
2Stem Elbows 1/4 x 1/4QC 2
3Flow Restrictor 1/2 gpm 1
41/4” OD Tubing - White - 5’ 1
Under sink Install Kit
Locate the cold water supply valve and turn if o.
Unscrew the faucet supply tube on top of the angle
stop. Install the angle stop adapter to the top of the
angle stop. Install the faucet supply line on the top of
the angle stop adapter. Turn the adapter valve to the
closed posion and turn the cold water valve back on.
Check for leaks
Angle stop adapter
Flow Restrictor
Stem ElbowStem Elbow
AquaChoice
Filter Cartridge
AquaChoice
Filter Head
1
4
3
2
2
1. Install Filter head on cabinet wall
Place the lter head on a cabinet wall in a convenient
spot and allow for 2” clearance for lter changes.
Filter must hang from the head vercally
2. Install the feed supply adapter on the cold
water angle stop valve
3. Install and connect tubing to the lter and run tube to appliance
Push clean cut end of 1/4” OD tubing into the angle stop adapter valve. Measure and cut the amount needed to insert
into the stem elbow that will insert into the inlet side of the head. Insert the cut piece into the other stem elbow that
goes into the outlet side. Cut the tubing a few inches from the stem elbow to insert the ow restrictor. Make sure the
ow direcon arrow on the restrictor is in the same direcon as ow (towards the appliance)
4. Flush prior to use
Before the nal connecon to the appliance, ush the cartridge for 5 minutes to ush out any carbon nes prior to
nal hook up and use. Now connect the appliance and enjoy.