
To stabilize the combat equipment to the parachutist during exit, fall, and
parachute deployment, parachutists step through the pack’s shoulder straps.
The SOF harness system has the ability to be a single or dual-point release
assembly that allows parachutists to lower their combat equipment prior to
landing.
RIGGING THE SOF HARNESS TO THE COMBAT PACK
Before attaching the SOF Harness and PASS Straps to the combat pack, lay the
harness out on clean, flat surface, so that solid links facedownward.
• Places the pack on the harness with pockets facing down, frame up, with top of
pack facing free ends of main harness webbing.
• Routes the cross strap around pack, and mates into respective friction adapter.
• Routes the main, diagonal strap friction adapters through webbing on bottom of
pack and under frame or waist belt, if possible. Solid Link attaching points
should be even with or 4-5 inches from bottom of pack. This allows jumper to get
pack as high as possible when mounted to harness.
• Routes free ends of main, diagonal straps over pack lid (through webbing on top
lid, if present), though pack carry handle, and crossing in center of pack, over
cross strap, making an X. Weave through friction adapters.
• Turns the pack over and adjusts cross strap around pockets, centers harness.
• Tightens all straps, then rolls the excess webbing and secures it with retainer
bands or tape. Folds and secures loose ends with elastic bands or tape.
• Attaches the HPT lowering line by routing the loop end under crossed diagonal
straps and passes running end through the loop(girth hitch). Attach HPT
lowering line to side of pack with retainer bands. For MFF operations, suggest
securing HPT lowering line to left side of pack as wearing it.
• Attaches PASS Straps to SOF harness by routing webbing through Solid Link
attaching point on harness and back into Friction Adapter on attaching strap, so
that adapters are facing away from jumper when pack is mounted. Repeat other
side.
FROMA, INC
www.fromafab.com