FrSky FAS40 ADV User manual

Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS40 ADV
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Connect the output Port of the sensor to the receiver, select Smart Port or FBUS on the receiver setup screen, the
sensor will automatically recognize.
Protocol switching
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com and
click the support tab for this product.
Thank you for purchasing FrSky Current Sensor – FAS40 ADV. It is designed for FrSky Smart Port enabled system,
and can measure Current (A) and Battery Voltage (V) when connected between a Battery and ESC. In order to fully
enjoy the benefit of it, please read the instruction manual carefully and set up the device as described below.
Introduction
ID Set Up
Note: All sensors could daisy chain with each other through their Smart Port or FBUS.
Each type of FrSky sensors has its unique physical ID. The default physical ID for this sensor is 02. The ID number
could be changed by Free Link (Windows/android/ios)
Specifications
• Dimension: 65.24×15.7×16.6mm (L×W×H)
• Weight: 16g
• Measurement range: 0~40A
• Current consumption:16mA@5V
• Maximum safe current: 40A
• Maximum battery voltage: 6S
• Compatible: Receivers with Frsky Smart Port or FBUS function
• Connector: XT60 Anti spark
FBUS
Warning: Install FrSky Current Sensor – FAS40 ADV on any appropriate surface of the airframe that
stays away from water, vibration, or fuel.
Other FrSky S.Port or FBUS enabled sensors include new Smart Port or FBUS enabled Variometer Sensor, GPS
Sensor, RPM Sensor, Airspeed Sensor, and so on.
FrSky Current Sensor – FAS40 ADV
is compatible with FrSky Smart Port or FBUS enabled receivers. For more
details, please refer to corresponding receiver instruction manual.
Set Up
FBUS
Bat
ESC
To the S.Port or FBUS
of FrSky receivers
RECEIVER
To other FrSky
S.Port Enabled Sensor

Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS40 ADV
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
The Battery and ESC should be connected to BAT port and ESC port correspondingly and make sure the polarity is
correct. FrSky is not responsible for any damage caused by wrong polarity connection.
LED Status
FBUS
NO
YES
LED Status
Flash slowly
Flash quickly
S.Port
YES
NO