Yes to Filter Prompt
1. Computer displays FILTER
NOW? Yes no and the blue
LED flashes.
2. Press 91 (YES) .
3. Computer displays SKIM VAT.
4. Use skimmer to remove debris from
frypot.
5. Computer displays
CONFIrM?
Yes no.
6. Press 91 (YES) .
7. Computer displays
draining,
washing, FILLING during fil-
tration.
8. Computer displays
LOW TEMP
until back to operating temperature.
9. Computer displays product name or
dashed lines.
No to Filter Prompt
1. Computer displays FiLTER
NOW? Yes no and the blue
LED flashes.
2. Press 82 (NO).
3. Fryer resumes normal operation.
JIB System (Jug In Box)
1. Orange LED on fryer lights.
2. Open cabinet door to access JIB.
3. Remove oil line from JIB
4. Remove JIB.
5. Open new oil jug and remove liner
under cap.
6. Position pick-up tube in new box
with attached cap in place.
7. Position the new jug in the fryer
cabinet.
8. Press and hold orange reset button
until orange LED goes out.
Bulk Oil System
1. Orange LED on fryer lights.
2. Open JIB door.
3. Press and hold orange reset button
until the jug is full then release.
DO NOT OVERFILL THE JUG.
4. Orange light goes out.
Responding to Filtration Questions on the M3000 Computer Display
Responding to Low
Oil Warning Light
Responding to Fryer
Filter Prompts
Is Vat Full?
1. Computer displays IS VAT FULL?
yes/no *.
2. Press 82 (NO).
3. Computer displays FILLING, as the oil is being
pumped back to the frypot.
4. After pumping cycle quits, computer displays IS
VAT FULL? Yes/no.
5. If pot is filled press 91 (YES) and go to Step 9.
6. If pot is not filled, press 82 (NO). The pump will run
again for 30 seconds and display Is VAT
FULL? Yes /no. (Three unsuccessful
attempts to fill the vat will lead to a change
filter pad? YES/NO display.)
7. Computer displays Change Filter pad?
YES/NO. Press 91 (YES) .
8. Clean the filter pan and replace the filter paper and
powder.
9. Once the pan is pulled from the cabinet for a mini-
mum of thirty seconds the computer display returns
to the last state or OFF.
10. Re-install the filter pan.
*NOTE: After six unsuccessful attempts to fill the vat, the
fryer displays Service Required. Pressing NO
allows cooking , but the fryer will re-prompt every 15 min-
utes. Call for service.
Clogged Drain
1. Computer displays CLEAR DRAIN changing to
IS DRAIN CLEAR? alternating with YES.
2. Clear debris from the drain using the fryer’s friend
and press the 9(1yes) button once the drain is
cleared to continue.
3. The computer displays DRAINING and normal
auto filtration operation resumes.
1. Press and hold Filter button for three
seconds (right side for full vat; desired
side for split vat).
2. Computer chirps, displays
FILTER
MENU and AUTO FILTER.
3. Use button to scroll to MAINT FILTER .
4. Press 91 .
5. Computer displays
MAINT
FILTER? and YES NO.
6. Press 91 (YES).
7. Computer displays
FIL-
TERING.
8. Oil drains from frypot
9. Computer displays
SCRUB
VAT COMPLETE? and
YES.
10. Scrub vat and Press 91 (YES).
11. Computer displays
is oil sensor
clean? and YES (gas only).
12. Clean oil sensor (gas only) with a no
scratch pad and press 91 (YES) (see
photo).
13. Computer displays WASH VAT? and
YES.
14. Press 91 (YES).
15. Oil flows across frypot and computer
displays WASHING.
16. Computer displays
WASH AGAIN?
and YES NO.
17. Press 82 for NO; 91 for YES.
18. After NO response, computer displays
RINSING.
19. Oil washes across frypot.
20. Computer Displays
RINSE AGAIN?
and YES NO.
21. Press 82 for NO; 91 for YES.
22. After NO response, computer
displays POLISH? and YES NO.
23. Press 91
24. Oil flows through frypot.
25. Computer displays
POLISH-
ING and a five-minute countdown
timer.
26. After five minutes, or a pressing of the
82 button to stop the polishing, the
computer displays FILL VAT? and
YES.
27. Press 91 (YES).
28. Frypot fills and displays FILLING.
29. Computer displays IS VAT FULL?
and YES NO.
30. Press 91 for yes; 82 for no.
31. With yes selection, computer displays
OFF.
32. With a no selection, pump runs and
steps repeat, starting at step 29.
819-686705/11 LOV™ Fryer
LOV Quick Reference
Daily Maintenance Filtration
En. Can.
