Stylistic 2300 is a trademark of Fujitsu Personal Systems, Inc.
© 1998 Fujitsu Personal Systems, Inc.
9/98 58-0601-00A
FMWSP6 Screen Protector
Installation Instructions
Stylistic 2300
The FMWSP6 screen protector can be installed on
the Stylistic 2300 pen tablet display screen or on the
display window of the FMWCC30 harsh
environment case. Note the following:
• Before installing a new screen protector, remove
any screen protector that is already installed. (A
notch in the corner of the screen protector allows
you to slide your fingernail or a sharp
implement under the screen protector for
removal.)
• To ensure good adhesion, clean the display
screen with a soft cotton cloth dampened with
denatured alcohol before installing the screen
protector.
1.For installation on the Harsh Environment Case
only: Remove edge from screen protector.
2.Peel protective film from adhesive side of screen
protector.
3.Install the screen protector. Apply the adhesive
side to the screen with the notch in the lower left
corner. Apply pressure along the edge of the
screen protector with your finger. (Avoid lifting
the screen protector from the screen after it is
installed. The adhesive requires 48 hours to cure.)
4.Remove the protective film from top of the screen
protector.
5.Clean the exposed surface of the screen protector
with a soft cotton cloth dampened with denatured
alcohol to remove any adhesive left behind by the
protective film.
