2
Handset settings
Up/Down
LED Display
Save
Presets
1. Move the table to the desired height.
2. Press .
3. Press memory position ‘1’ or ‘2’.
4. Display will show ‘S 1’ or ‘S2’. Table
height will be display again after a few
seconds.
Setting Memory Preset
1. Press ‘1’ , ‘2’ , and 5 for 3 seconds.
The display will show ‘S0’.
2. Press 5until it shows ‘S5’.
3. Press .
Change Readout Between
Inches and Centimeters
Adjust the Height Readout
1. Press and release it.
2. Then press and hold the for longer
than 5 seconds.
3. When display starts flashing, adjust the
readout with 5 and .
4. To save press .
Move to Memory Preset
Europe: Press and hold ‘1’ or ‘2’ until desk
reaches preset height.
North America: Either press and hold ‘1’ or ‘2’,
until desk reaches preset height. Or double
press ‘1’ or ‘2’ and it will move to preset height
automatically.
1. Press the until the desk reaches the
lowest position. Release the .
2. Press and hold for about 5 seconds
until the desk moves down and then up.
Release.
Initial Calibration/Reset
