Furinno NT11249 User manual

MODEL: NT11249
3 DRAWERS CHEST
Date: 16.10.2014

BEFORE YOU BEGIN, PLEASE READ ASSEMBLY INSTRUCTIONS CAREFULLY.
FOLLOW THEM STEP BY STEP.
CAUTION:
1. ADULT SUPERVISION IS REQUIRED DUE TO SMALL PARTS.
CARE SHOULD BE TAKEN IN THE UNPACKING AND ASSEMBLY OF THE PRODUCT.
2. ASSEMBLE ON SOFT SURFACES TO PREVENT DAMAGE TO THE PRODUCT FINISH.
3. MAKE SURE ALL PARTS ARE INCLUDED BEFORE ASSEMBLY.
Date: 16.10.2014

ASSEMBLY INSTRUCTION
STEP 1
INSERT DOWEL (A) TO THE PRE-HOLES OF PANEL (2)(3)(4)(5)(6).
STEP 2
FIX LOCK SWITCH (D) INTO THE CAM LOCK OF EVERY PANELS, BEFORE ASSEMBLY THE UNIT.
Date: 16.10.2014

STEP 3
ATTACH PANEL (4)(5)(6) TO PANEL (2).
TURN ON CAM LOCK AND FIX INTO THE PRE-DRILLED NUT.
TURN OFF CAM LOCK WHEN THE PANEL WERE FIXED.
Date: 16.10.2014

STEP 4
ATTACH PANEL (3) TO ASSEMBLED UNIT.
REPEAT THE SAME METHOD AS STEP 3.
STEP 5
UPRIGHT THE UNIT. ATTACH PANEL (1) TO IT.
REPEAT THE SAME METHOD AS STEP 3.
Date: 16.10.2014

STEP 6
FIX PANEL (7) TO THE REAR POSITION OF UNIT.
INSERT PLASTIC PIN & NUT (C) AND PLASTIC STOPPER (B) INTO THE PRE-HOLES OF PANEL (7).
Date: 16.10.2014

STEP 7
ATTACH PANEL (11) TO PANEL (9) & (11).
REPEAT THE SAME METHOD AS STEP 3.
STEP 8
SLOT IN PANEL (12) TO PANEL (9) & (10), AS SHOWN.
ATTACH PANEL (8) TO THE ASSEMBLED SECTION.
REPEAT THE SAME METHOD AS STEP 3.
Date: 16.10.2014

STEP 10
SLIDE 3 NOS. OF DRAWER INTO TH UNIT.
INSERT RUNNER STOPPER (F) TO THE PRE-DRILLED HOLE
OF DRAWER SIDE PANEL (9)(10), AS SHOWN.
STEP 9
FIX THE HANDLE SET (E) TO THE PANEL (8).
Date: 16.10.2014